New control scheme of on-load tap changer for voltage regulation in active distribution systems using Fuzzy logic

نویسندگان

چکیده

This research presents a new voltage regulation philosophy that enhances the magnitude in power distribution network where distributed generation (DG) is prevalent. Voltage networks relies heavily on On-Load Tap-Changer (OLTC) installed transformers. Since it was designed for without DG, OLTC's current scheme uses fixed reference and hence cannot regulate network. Therefore, proposed novel system-based Fuzzy logic will compute set point OLTC must follow to mitigate undesirable DG impact profile. The suggested system evaluated Morocco's MATLAB/Simulink-built 20kV

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Improvement of on-load tap changer performance in voltage regulation of MV distribution systems with DG units using D-STATCOM

This paper presents a new technique for the voltage regulation of a radial medium voltage (MV) distribution grid in presence of distributed generation (DG) units. The proposed technique consists of the coordinated action of on-load tap changer (OLTC) of transformer and reactive power compensation by D-STATCOM. Managing the system voltage using the action of OLTC is one of the most common ways f...

متن کامل

Effect of Solid-State on Load Distribution Transformer Tap-Changer on Power Quality Enhancement

Recently electronic tap-changer has received more attention due to its quick response, better performance and simpler maintenance compared to the mechanical tap-changer. This paper presents the capability of the distribution transformer equipped with an electronic tap-changer for improving power quality. At this end, the analytical computation for determining the compensating limit of electroni...

متن کامل

Innovative Transformer Load Tap Changer Control Using Ethernet-Based Communications

This paper describes the design of a load tap changer (LTC) control for up to four parallel transformers using a modified circulating current approach. The LTC control discussed in this paper was implemented using programmable logic, math functions, and IEC 61850 communications over fiber-optic Ethernet. One LTC control is associated with each transformer. The current angle from each LTC contro...

متن کامل

Solid - State On Load Tap - Changer for Transformer Using Microcontroller

The on-load tap changing (OLTC) regulators have been widely used since the introduction of electrical energy. They ensure a good regulation of the output voltage in presence of large variations of the input voltage with typical response time from several mili-seconds to several seconds. Earlier mechanical type of on load tap changers were into practice. But they had considerable limitations and...

متن کامل

a new type-ii fuzzy logic based controller for non-linear dynamical systems with application to 3-psp parallel robot

abstract type-ii fuzzy logic has shown its superiority over traditional fuzzy logic when dealing with uncertainty. type-ii fuzzy logic controllers are however newer and more promising approaches that have been recently applied to various fields due to their significant contribution especially when the noise (as an important instance of uncertainty) emerges. during the design of type- i fuz...

15 صفحه اول

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: ITM web of conferences

سال: 2022

ISSN: ['2271-2097', '2431-7578']

DOI: https://doi.org/10.1051/itmconf/20224804001