Neutron Diffraction Study on Anisotropy of Strain Age Hardening in Ferritic Steel
نویسندگان
چکیده
منابع مشابه
Neutron diffraction investigations on residual stresses contributing to the fatigue crack growth in ferritic steel tubular bridges
Fatigue crack growth observed in tubular K-joint specimens, typical of tubular bridge structures, always initiates at the chord crown toe locations whether the applied stress range is tensile or compressive. Even though other locations around the weld have highest hot-spot stresses, chord crown toe locations are still the most critical. This raises the question about the relevant tensile residu...
متن کاملStrong Ferritic – Steel Welds
There are many steels which are stronger than 2000 MPa, with toughness values exceeding 100 MPa m and which have been in commercial service for many decades. Examples include the marageing alloys and carbide–free bainitic steels. By contrast, welding consumables with a proof strength in excess of 1000 MPa are few and far between. This is because whereas wrought steels can be thermomechanically ...
متن کاملStrain hardening and heterogeneous deformation during twinning in Hadfield steel
We identify the role of deformation twinning and twin–twin intersections on the strain hardening behavior of Hadfield steel single crystals using strain field measurements. In situ and ex situ strain field measurements resolved at micrometer length scales are obtained using digital image correlation. Ex situ measurements reveal that macroscopic twin-bands, which are composed of a mixture of fin...
متن کاملStrain hardening behavior of aluminum alloyed Hadfield steel single crystals
Very high strain hardening coefficients (=G/23) are observed for aluminum-alloyed face-centered cubic Hadfield steel single crystals under tensile loading. Alloying with aluminum suppressed deformation twinning in two of the three crystallographic orientations studied, and transmission electron microscopy results revealed the existence of dense dislocation walls (sheets) along crystallographic ...
متن کاملQuantification of ridging in ferritic stainless steel sheets by electron backscattered diffraction R-value maps.
In ferritic stainless steel (FSS), undesirable surface defects of ridging appear during deep drawing. The formation of these defects is attributed to the inhomogeneous distribution of orientations of individual grains. In the present work, a new electron backscattered diffraction R(α)-value map was introduced, and the dependence of the tensile directions on the formation of ridging in an FSS sh...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2012
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.98.262