Multiple Optimization of Cutting Parameters Affecting Kerf Formation and Surface Roughness in Laser Cutting of Al 5052 Alloy

Optimization of Cutting Parameters for Surface Roughness in Turning

The optimized cutting parameters are very important to control the required surface quality. In the present study, Taguchi method is used to find the optimal cutting parameters for surface roughness (Ra) in turning. The L-18 orthogonal array, the signal-to-noise ratio & analysis of variance are employed to study the performance characteristics in turning operations of AISI-410 steel bars using ...

Multi Objective Optimization of Cutting Parameters in Turning Operation to Reduce Surface Roughness and Cutting Forces

ANN modeling of kerf taper angle in CO2 laser cutting and optimization of cutting parameters using Monte Carlo method

Article history: Received June 6 2014 Received in Revised Format September 9 2014 Accepted September 15 2014 Available online September 22 2014 In this paper, an attempt has been made to develop a mathematical model in order to study the relationship between laser cutting parameters such as laser power, cutting speed, assist gas pressure and focus position, and kerf taper angle obtained in CO2 ...

Effects of the Cutting Fluid Types and Cutting Parameters on Surface Roughness and Thrust Force

In this study, three different vegetable-based cutting fluids developed from raw and refined sunflower oil and two commercial types (vegetable and mineral based cutting oils), were carried out to determine for thrust force and surface roughness during drilling of AISI 304 austenitic stainless steel with HSSE tool. The uses of vegetable cutting oils was investigated in reducing thrust force and ...

experimental investigations in order to evaluate the kerf and surface roughness in the laser cutting process of inconel 718 superalloy and process optimization

0