Morphological investigation and mechanical behaviour of agrowaste reinforced aluminium alloy 8011 for service life improvement
نویسندگان
چکیده
منابع مشابه
Effects of Solidification Time on Mechanical Properties and Wear Behaviour of Sand Cast Aluminium Alloy
An investigation was carried out to understand the effects of solidification time of the cylindrical specimen on hardness, wear rate and the coefficient of friction of Aluminium alloy (LM4). The commercially available LM4 Aluminium alloy was melted in a crucible furnace under argon atmosphere. The molten metal was poured into sand moulds having dissimilar size holes. The cast rods were tested f...
متن کاملMechanical Behaviour and Corrosion of Interstitial-free Steel Aluminium Alloy Self-piercing Riveted Joints
.......................................................................................i-ii ACKNOWLEDGEMENTS...................................................................iii-iv CONTENTS......................................................................................v-vii LIST OF FIGURES...........................................................................viii-xiii LIST OF TABLES....
متن کاملWear behaviour of AA6061 aluminium alloy and its composites
This study investigates the wear resistance of four AA6061 MMCs together with the monolithic AA6061 alloy, all in the T6 condition, using a pin-on-disc test. In addition to the widely studied 20 vol.% Saffil MMCs, the present investigation considered a hybrid of 11% Saffil + 20% Sic, and a high volume fraction Sic, MMC. AA6061 + 60% Sic,. The wear behaviour against P400 Sic grit adhesive bonded...
متن کاملTENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملResidual Strength Improvement of an Aluminium Alloy Cracked Panel
This work deals with the application of the micromechanical Gurson-Tvergaard (GT) model to the determination of the residual strength of analuminumflat stiffened panel (2024 T3) with a central through crack, by means of finite element simulations. The load condition is represented by a monotonic traction along the direction orthogonal to the crack plane. The used Finite Element code is WARP 3D,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Heliyon
سال: 2020
ISSN: 2405-8440
DOI: 10.1016/j.heliyon.2020.e05506