Molecular Orientation of Polyamide Fiber during Melt Spinning Process
نویسندگان
چکیده
منابع مشابه
Simulation of Multifilament Semicrystalline Polymer Fiber Melt-Spinning
The goal of this effort is to provide an accurate simulation of multifilament fiber melt spinning, applicable for a wide range of material and process conditions. For ease of use, the model should run on a standard laptop or desktop computer in reasonable time (one hour or less). Most melt spinning models simulate the formation of a single filament, with little or no attention given to multifil...
متن کاملIn-Situ X-Ray Characterization of Fiber Structure During Melt Spinning
The properties of a polymer are strongly influenced by its morphology. In the case of fibers from semicrystalline polymers this consists of the degree of crystallinity, the spacing and alignment of the crystalline regions, and molecular orientation of the polymer chains in the amorphous regions. Information on crystallinity and orientation can be obtained from X-ray analysis. In-situ X-ray char...
متن کاملOptimal Control of Melt Spinning Processes
An optimal control problem for a mathematical model of a melt spinning process is considered. Newtonian and non–Newtonian models are used to describe the rheology of the polymeric material, the fiber is made of. The extrusion velocity of the polymer at the spinneret as well as the velocity and temperature of the quench air serve as control variables. A constrained optimization problem is derive...
متن کاملmatrix-fibril morphology and structure of polyblend fibers in melt spinning process: a review
the mechanism and the parameters affecting the matrix-fibril morphology in melt spun polyblend fibers are discussed. the properties of polymeric blends depend considerably on their final morphologies. blending of two miscible polymers, normally gives rise to formation of a single-phase morphology while blending of two immiscible polymers can create a two or three (in case of using compatibilize...
متن کاملEffect of Fiber Surface Treatment on Wear Characteristics of Carbon Fiber Reinforced Polyamide 6 Composites
Ozone modification method and air-oxidation were used for the surface treatment of polyacrylonitrile(PAN)-based carbon fiber. The surface characteristics of carbon fibers were characterized by X-ray photoelectron spectroscopy (XPS). The interfacial properties of carbon fiber reinforced polyamide 6 (CF/PA6) composites were investigated by means of the single fiber pull-out tests. As a result...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Kobunshi Kagaku
سال: 1969
ISSN: 1884-8079,0023-2556
DOI: 10.1295/koron1944.26.39