Modelling and simulation of the dynamic cutting process and surface topography generation in nano/micro cutting
نویسندگان
چکیده
منابع مشابه
Modelling and Simulation of the Dynamic Cutting Process and Surface Topography Generation in Nano/micro Cutting Modelling and Simulation of the Dynamic Cutting Process and Surface Topography Generation in Nano/micro Cutting
In nano/micro cutting process, the surface quality is heavily dependent on all the dynamic factors in machining including those from the material, tooling, cutting parameters, servo accuracy, mechanical structure deformation, and non-linear factors as well. The machined surfaces are generated based on the tool profile and the real tool path combining with the various external and internal distu...
متن کاملSIMULATION AND MONITORING OF THE MACHINING PROCESS VIA FUZZY LOGIC AND CUTTING FORCES
On time replacement of a cutting tool with a new one is an important task in Flexible Manufacturing Systems (FMS). A fuzzy logic-based approach was used in the present study to predict and simulate the tool wear progress in turning operation. Cutting parameters and cutting forces were considered as the input and the wear rate was regarded as the output data in the fuzzy logic for construct...
متن کاملthe study of bright and surface discrete cavity solitons dynamics in saturable nonlinear media
امروزه سالیتون ها بعنوان امواج جایگزیده ای که تحت شرایط خاص بدون تغییر شکل در محیط منتشر می-شوند، زمینه مطالعات گسترده ای در حوزه اپتیک غیرخطی هستند. در این راستا توجه به پدیده پراش گسسته، که بعنوان عامل پهن شدگی باریکه نوری در آرایه ای از موجبرهای جفت شده، ظاهر می گردد، ضروری است، زیرا سالیتون های گسسته از خنثی شدن پراش گسسته در این سیستم ها بوسیله عوامل غیرخطی بوجود می آیند. گسستگی سیستم عامل...
Experimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملSimulation of Cutting Process in Turning
This paper presents simulation of cutting process by turning of polyamide PA 66, the simulation based on approach Arbitrary Lagrangian Eulerian, ALE. Was taken into account a tool knife CNMA from Coromant. The flow stress of the workpiece is modeled as function of strain, strain rate and temperature, so as to reflect its dynamic changes in physical properties. In this way, the influences of dep...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Nanomanufacturing
سال: 2009
ISSN: 1746-9392,1746-9406
DOI: 10.1504/ijnm.2009.027047