Modeling and Optimization of Superhydrophobic Condensation
نویسندگان
چکیده
منابع مشابه
Scale effect on dropwise condensation on superhydrophobic surfaces.
Micro/nano (two-tier) structures are often employed to achieve superhydrophobicity. In condensation, utilizing such a surface is not necessarily advantageous because the macroscopically observed Cassie droplets are usually in fact partial Wenzel in condensation. The increase in contact angle through introducing microstructures on such two-tier roughened surfaces may result in an increase in dro...
متن کاملElectric-field-enhanced condensation on superhydrophobic nanostructured surfaces.
When condensed droplets coalesce on a superhydrophobic nanostructured surface, the resulting droplet can jump due to the conversion of excess surface energy into kinetic energy. This phenomenon has been shown to enhance condensation heat transfer by up to 30% compared to state-of-the-art dropwise condensing surfaces. However, after the droplets jump away from the surface, the existence of the v...
متن کاملJumping-droplet-enhanced condensation on scalable superhydrophobic nanostructured surfaces.
When droplets coalesce on a superhydrophobic nanostructured surface, the resulting droplet can jump from the surface due to the release of excess surface energy. If designed properly, these superhydrophobic nanostructured surfaces can not only allow for easy droplet removal at micrometric length scales during condensation but also promise to enhance heat transfer performance. However, the ratio...
متن کاملTowards optimization of patterned superhydrophobic surfaces.
Experimental and theoretical study of wetting properties of patterned Si surfaces with cylindrical flat-top pillars of various sizes and pitch distances is presented. The values of the contact angle (CA), contact angle hysteresis (CAH) and tilt angle (TA) are measured and compared with the theoretical values. Transition from the composite solid-liquid-air to the homogeneous solid-liquid interfa...
متن کاملHierarchical roughness optimization for biomimetic superhydrophobic surfaces.
Superhydrophobic surfaces should have high contact angles (CA) with water and low contact angle hysteresis (CAH). High CA may be achieved by increasing surface roughness, while in order to have low CAH, superhydrophobic surfaces should be able to form a stable composite interface with air pockets between solid and liquid. Capillary waves, nanodroplets condensation, hydrophilic spots due to chem...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Heat Transfer
سال: 2013
ISSN: 0022-1481,1528-8943
DOI: 10.1115/1.4024597