Miniaturized Capillary Electrophoresis Fabricated on Pyrex Glass Chips Using Deep Dry Etching and Anodic Bonding.
نویسندگان
چکیده
منابع مشابه
Deep Wet and Dry Etching of Pyrex Glass: a Review
This paper is a review of wet and dry etching of one of the most common types of glass: Pyrex. The paper analyzes the methods for increasing the glass etch rate in HF solutions, namely, annealing, concentration, ultrasonic agitation and temperature. The limitations of the wet etching of glass are also presented. Mashing layers commonly used for deep wet etching of glass are analyzed, in terms o...
متن کاملLaser desorption ionization (LDI) silicon nanopost array chips fabricated using deep UV projection lithography and deep reactive ion etching
Deep UV projection lithography (DUV-PL) and deep reactive ion etching (DRIE) processes are used to fabricate silicon nanopost surfaces for laser desorption ionization mass spectrometry (LDI-MS). Described here is a fabrication process that is amenable to mass production of silicon nanopost array (NAPA) devices optimized for laser desorption ionization mass spectrometry of small molecules less t...
متن کاملStudy on the Glass Silicon Anodic Direct Bonding Parameters
By MEMS packaging test platform for bonding process of bonding temperature and bonding time, and test silicon specifications experimental study. Experimental results indicate that when the bonding voltage of 1200V, bonding temperature of 445 0 C to 455 0 C, bonding time is 60s, the void fraction is less than 5%. Glass and silicon wafer bonding quality can achieve the best. The experimental resu...
متن کاملMicromachined Heat Exchanger for a Cryosurgical Probe
This paper describes a lithography-based microfabrication process developed for a recuperative heat exchanger intended for use in a cryosurgical probe. The probe, which uses the Joule-Thomson (JT) cooling cycle, must achieve a temperature < -50°C, with a freeze rate of 25-50°C/min. The heat exchanger must maintain high stream-to-stream thermal conductance while restricting parasitic stream-wise...
متن کاملA Macroporous TiO2 Oxygen Sensor Fabricated Using Anodic Aluminium Oxide as an Etching Mask
An innovative fabrication method to produce a macroporous Si surface by employing an anodic aluminium oxide (AAO) nanopore array layer as an etching template is presented. Combining AAO with a reactive ion etching (RIE) processes, a homogeneous and macroporous silicon surface can be effectively configured by modulating AAO process parameters and alumina film thickness, thus hopefully replacing ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Photopolymer Science and Technology
سال: 2002
ISSN: 0914-9244,1349-6336
DOI: 10.2494/photopolymer.15.311