Microwave Time Domain Measurements for Measuring Thicknesses of Mold Powder Layers
نویسندگان
چکیده
منابع مشابه
Experimental determination of layers films thicknesses
The determination of particle induced x-ray emission (PIXE) cross sections and the concentration of elements in a material require the knowledge of the target sample thickness. In this aim, measurements of the thickness by three different methods have been performed. These are absorption of X-rays by a 55 Fe source, transmission of alpha particles by a 241 Am source and Rutherford backscatterin...
متن کاملKinetic Study of the Devitrification of Mold Powder Slags
Due to the rapid cooling of the slag infiltrated into the mold-strand gap, it is expected that the rate of devitrification of the glass formed plays a key role in determining the proportion of crystalline phases influencing mold heat transfer. In this investigation, a novel procedure to calculate Time-Temperature-Transformation (TTT) curves of mold slags is presented. It is based on the integra...
متن کاملimproving thickness estimation for thin layers in quefrency domain
obtaining a seismic section with high temporal and spatial resolution was always one of the goals of seismic data processors and interpreters. accurate estimation of the thicknesses of thin beds is an important tool in this regard. the basic problem is that the wavelength of the signal must be similar in dimention to that of the bed thinness. if it is much longer than the bed thinness, the dete...
متن کاملFrequency domain complex permittivity measurements at microwave frequencies
Overview of frequency domain measurement techniques of the complex permittivity at microwave frequencies is presented. The methods are divided into two categories: resonant and non-resonant ones. In the first category several methods are discussed such as cavity resonator techniques, dielectric resonator techniques, open resonator techniques and resonators for non-destructive testing. The gener...
متن کاملTRANSISTOR MODELING Microwave Transistor Modeling for Time Domain Simulation
High frequency models of transistors are of interest because they have applications to computeraided design of high frequency circuits. When these models are derived, a problem encountered is that measured transistor S-parameters do not agree with the hybrid-π model. In this article, a simplified method is described to obtain an optimized classical hybrid-π model that predicts the measured S-pa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2018
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.tetsu-2018-002