Microwave drying of wet processed wood fibre insulating boards
نویسندگان
چکیده
منابع مشابه
Microwave Drying of Wood Strands
Characteristics of microwave drying of wood strands with different initial moisture contents and geometries were investigated using a commercial 10 small microwave oven under different power inputs. Temperature and moisture changes along with the drying efficiency were examined at different drying scenar ios. Extractives were analyzed using gas chromatography=mass spectrometry (GC=MS). The res...
متن کاملAutomated Visual Inspection: Wood Boards
The majority of scientific papers focusing on wood classification for pencil manufacturing take into account defects and visual appearance. Traditional methodologies are based on texture analysis by co-occurrence matrix, by image modeling, or by tonal measures over the plate surface. In this work, we propose to classify plates of wood without biological defects like insect holes, nodes, and cra...
متن کاملSlip Modeling in Timber-Framed Walls with Wood-Based or Fibre-Plaster Sheathing Boards
The paper provides mathematical modelling for prefabricated timber-framed walls composed of a timber frame and two different types of sheathing boards. Since by wood-based boards (WBB) the tensile strength is similar to the compressive one, there are practically no cracks appearing in the boards. On the other hand, in case of fibre-plaster sheathing boards (FPB) the tensile strength is approxim...
متن کاملFibre Level Modelling of Free Water Behaviour during Wood Drying and Wetting♣
Most drying simulation models describe the moisture migration in wood as a diffusion process, including free water flow at contents greater than the fibre saturation point. This means that wood is seen as a homogeneous material lacking internal structure. However, especially in softwood narrow sections, bordered pits, divide the free water phase into rather distinct units. It is thus quite clea...
متن کاملSurface Colour Change in Wood during Drying above and below Fibre Saturation Point
A technique, useful for studying the formation of kiln brown stain in wood drying, has been developed to measure the surface colour change in a single board wood sample during drying. The wood sample is planed carefully in the green state to remove any surface wood that was damaged during cutting. The intact tracheids at the surface cause the evaporative front to remain at the surface during dr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: European Journal of Wood and Wood Products
سال: 2009
ISSN: 0018-3768,1436-736X
DOI: 10.1007/s00107-008-0306-9