Microstructure and wear studies of laser clad Al-Si/SiC(p) composite coatings
نویسندگان
چکیده
منابع مشابه
Microstructure and Wear Resistance of Laser-Clad (Co, Ni)61.2B26.2Si7.8Ta4.8 Coatings
Key Laboratory of Materials Modification by Laser, Ion and Electron Beams (Ministry of Education), School of Materials Science and Engineering, Dalian University of Technology, Dalian 116024, China; [email protected] (L.Z.); [email protected] (S.Q.); [email protected] (Q.Y.) * Correspondence: [email protected] (C.W.); [email protected] (C.D.); Tel.: +86-0411-8470-8449 (C.W.)...
متن کاملLaser processing and microstructure of Al-Cu-Fe quasicrystalline coatings on Al-base materials
There is a large interest in using high power lasers for surface alloying or cladding on aluminium alloys, in order to enhance hardness and to improve wear resistance. A partly quasicrystalline surface layer (QC) (Al-Cu-Fe coating) has been obtained by laser cladding on Al-base materials. In addition to crystalline phases (Al5Fe2 and AlisFe4t -with dissolved copper), a quasicrystalline Al-Cu-Fe...
متن کاملMicrostructure and Dry-Sliding Wear Behavior of B4C Ceramic Particulate Reinforced Al 5083 Matrix Composite
B4C ceramic particulate–reinforced Al 5083 matrix composite with various B4C content was fabricated successfully via hot-press sintering under Argon atmosphere. B4C particles presented relative high wettability, bonding strength and symmetrical distribution in the Al 5083 matrix. The hardness value, friction coefficient and wear resistance of the composite were higher than those of the Al 5083 ...
متن کاملEvaluation of Microstructure and Wear Behavior of Iron-based Hard - facing Coatings on the Mo40 Steel
Mo40 low-alloy steels are mostly used to produce industrial components such as crane wheels which are exposed to abrasive wear. However, during working conditions, their wear resistance is reduced after a while due to its low hardness. With increasing abrasive wear, the dimensions of components decrease and they need to be repaired for surface modification. In this regard, hard overlay coatings...
متن کاملMicrostructures and Properties of Laser Cladding Al-TiC-CeO2 Composite Coatings
Al-TiC-CeO₂ composite coatings have been prepared by using a laser cladding technique, and the microstructure and properties of the resulting composite coatings have been investigated using scanning electron microscopy (SEM), a 3D microscope system, X-ray diffraction (XRD), micro-hardness testing, X-ray stress measurements, friction and wear testing, and an electrochemical workstation. The resu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Surface and Coatings Technology
سال: 2007
ISSN: 0257-8972
DOI: 10.1016/j.surfcoat.2007.04.003