Microstructural Characteristics of Ti-Al-Dy Alloy Produced by High Energy Ball Milling
نویسندگان
چکیده
منابع مشابه
Formation of glassy Ti50Cu20Ni24Si4B2 alloy by high-energy ball milling
The elemental powder mixtures with a nominal composition of Ti50Cu20Ni24Si4B2 can be amorphized under high-energy ball milling. A well-defined glass transition before crystallization appears in the obtained amorphous phase during heating in a differential scanning calorimeter. Awide supercooled liquid region DTx is available to be about 57 K. Crystallization of the ballmilled amorphous phase wa...
متن کاملThe Influence of Heat Treatment and High Energy Ball Milling on the Density, Hardness, and Wear Behavior of Al 7150 Alloy via Hot Uniaxial Compaction
The effect of the milling time & ageing on the hardness, density, and wear characteristics of Al 7150 alloy specimens made via powder metallurgy has been studied. The different constituents of Al 7150 alloy were processed in a planetary ball milling set up with a BPR of 10:1 for 5 hours, 10 hours, and 20 hours. At 400 °C, the milled powders were subsequently hot compacted in a punch die setup. ...
متن کاملAl4C3/Ag Formation in an Aluminum Composite Produced by High-Energy Ball Milling
Aluminum and its alloys have a lot of industrial applications due to their appropriate physical and chemical characteristics. However, those present a modest mechanical performance. One method to improve its strenght is the addition of hard insoluble particles as: carbides (Al4C3, TiC), oxides (Al2O3) or nitrides (TiN, AlN), which can difficult the dislocation movement at atomic level, resultin...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملEVect of high energy ball milling on titanium– hydroxyapatite powders
to bone are concerned are brittle materials as exempli ed by hydroxyapatite and ‘Bioglass’. Bioactive coatings are This paper reports on an investigationof the potential employed on metal implants to facilitate bonding to bone use of high energy ball milling (HEBM) for the while retaining the good combination of mechanical production of homogeneous mixtures of titanium/ properties associated w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Archives of Metallurgy and Materials
سال: 2023
ISSN: ['1733-3490', '2300-1909']
DOI: https://doi.org/10.24425/amm.2021.136381