Micrograin superplasticity of (.ALPHA.+.BETA.) brass.
نویسندگان
چکیده
منابع مشابه
Micrograin Superplasticity: Characteristics and Utilization
Micrograin Superplasticity refers to the ability of fine-grained materials (1 µm < d < 10 μm, where d is the grain size) to exhibit extensive neck-free elongations during deformation at elevated temperatures. Over the past three decades, good progress has been made in rationalizing this phenomenon. The present paper provides a brief review on this progress in several areas that have been relate...
متن کاملSuperplasticity of Annealed H13 Steel
H13 steel is a widely used hot work die material. A new type of hot working method is imperative to develop complex and precise dies. In this paper, the heat treatment of H13 steel (AISI) was carried out by annealing, the final structure is a point or spherical pearlite, and the grain size is about 30-40 μm. The tensile properties of the annealed microstructure were investigated at 650, 750, an...
متن کاملTRANSFORMATION SUPERPLASTICITY OF SUPER a2 TITANIUM ALUMINIDE
ÐTransformation superplasticity of an intermetallic Ti3Al-based alloy (Super a2) is demonstrated by thermal cycling about the a2/b transformation temperature range under a uniaxial tensile biasing stress. Failure strains up to 610% were recorded at a stress of 3 MPa, compared with 110% for deformation by isothermal creep at the same stress. The strain increment produced during each half-cycle i...
متن کاملSympathy or Brass Tacks
as A regional social worker for the Spastics Society I am increasingly aware of the diversity of my clients' needs, their dependence for facilities on specific geographical areas and the way local authorities interpret the statutory provisions. The knowledge that spasticity is irreversible makes an immediate impact. However I try I know I cannot change the status quo and this is the premise on ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1989
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.38.765