Micro Cutting of Wear and Impact Resistant Cemented Carbide in SEM
نویسندگان
چکیده
منابع مشابه
Wear Behavior in Micro and Nano-Structured WC-9Co-0.7VC Cemented Carbide Produced by Rapid Hot Press Sintering
The effect of CaO on the formation of β- and γ-zirconia nanoparticles from α-zirconia was investigated and their stability evaluated via mechanical activation. α-ZrO2+8.5wt%CaO powder was milled for 2-150 hours with ball-to-powder weight ratios (BPWR) of 40:1 and 60:1. Structural evaluations were conducted using X-Ray diffraction and scanning electron microscope (SEM). Thermal analysis wa...
متن کاملDevelopment of Creep-Resistant Tungsten Carbide Copper Cemented Carbide
Fine-grained tungsten carbide copper (WC-Cu) cemented carbide was sintered via spark plasma sintering at 1773K using a fine WC powder with a mean particle size of 0.11 mm. The mechanical properties were compared with tungsten carbide cobalt (WC-Co) cemented carbide and a binderless WC-sintered material. The Vickers hardness and fracture toughness obtained by the indentation fracture method for ...
متن کاملEvaluation of Flank Wear of Iron-rich Binder Carbide Cutting Tool in Turning of Titanium Alloy
Despite the fact that Titanium material has been considered as difficult to cut material, its usage has been increasing day by day in all engineering sectors; wherever criticality is encountered. Many studies are going on in view of increasing tool life at high cutting speed to improve productivity. In this study, attempt has been made to see the effect of iron as a partial substitution along ...
متن کاملInfluence of electrical discharge machining on sliding friction and wear of WC–Ni cemented carbide
Tribological characteristics of fine-grained WC–8 wt%Ni with different surface finishing conditions corresponding to sequential wire electrical discharge machining (wire-EDM) or grinding were investigated by performing dry reciprocating sliding experiments on TE77 pin-on-plate equipment with WC–6 wt%Co as mating material. Surface finishes and wear surfaces were characterized using surface topog...
متن کاملSEM and AFM Investigations of Surface Defects and Tool Wear of Multilayers Coated Carbide Inserts
Coated tool inserts can be considered as the backbone of machining processes due to their wear and heat resistance. However, defects of coating can degrade the integrity of these inserts and the number of these defects should be minimized or eliminated if possible. Recently, the advancement of coating processes and analytical tools open a new era for optimizing the coating tools. First, an over...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering, Contributed Papers
سال: 2005
ISSN: 1881-8722,1348-8724
DOI: 10.2493/jspe.71.926