Metal Matrix Composites 4 Design and innovation
نویسندگان
چکیده
منابع مشابه
Basics of Metal Matrix Composites
Metal composite materials have found application in many areas of daily life for quite some time. Often it is not realized that the application makes use of composite materials. These materials are produced in situ from the conventional production and processing of metals. Here, the Dalmatian sword with its meander structure, which results from welding two types of steel by repeated forging, ca...
متن کاملBi-continuous metal matrix composites
Bi-continuous alumina/aluminium composites were made by infiltrating an alumina preform which had the structure of a reticulated ceramic foam. The low density preforms were prepared from a polyurethane suspension of alumina powder which was pyrolysed and sintered after foaming. Higher density preforms consisted of ceramic foams with open cells. All these preforms were infiltrated with 6061 alum...
متن کاملTribocorrosion in Metal Matrix Composites
One of the biggest motivations behind the development of the metal matrix composites (MMCs) is the improvement of the mechanical wear resistance of the unreinforced metallic matrix material mainly by the load-bearing effect of the hard reinforcement phases. However, in a large number of applications, MMCs are also required to operate in intimate contact with aqueous environments, which may lead...
متن کاملOptimization of MWCNT – Metal Matrix Composites feedstocks
Micro powder injection moulding-μPIM is a powder injection moulding-PIM variant for microparts/devices. This study is about the optimization and respective production of nanocomposites feedstocks suitable to μPIM process. The optimization of MWCNT content in metal matrix composites-MMC feedstock were performed using torque rheometry until achieve homogeneous feedstocks with suitable flowability...
متن کاملCasting of SiC Reinforced Metal Matrix Composites
Composites based on two aluminium alloys (A536 and 6061) reinforced with 10% or 20% volume fraction of SiC particles were produced by gravity casting and a novel two-step mixing method was applied successfully to improve the wettability and distribution of the particles. The SiC particles were observed to be located predominantly in the interdendrit ic regions, and a thermal lag model is propos...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science and Technology
سال: 1994
ISSN: 0267-0836,1743-2847
DOI: 10.1179/026708394790164031