Mechanical properties and structures of Al-Cu alloys produced by heated mold continuous casting method (OCC).
نویسندگان
چکیده
منابع مشابه
Mechanical Properties of Magnesium Alloys Produced by the Heated Mold Continuous Casting Process
Investigation of the tensile and fatigue properties of cast magnesium alloys, created by the heated mold continuous casting process (HMC), was conducted. The mechanical properties of the Mg-HMC alloys were overall higher than those for the Mg alloys, made by the conventional gravity casting process (GC), and especially excellent mechanical properties were obtained for the Mg97Y2Zn1-HMC alloy. T...
متن کاملMagnetic Properties of Pr–Fe–Al Alloys Produced by the Metallic Mold Casting Method
The structures and magnetic properties of Pr–Fe–Al alloys produced by the metallic mold casting method were investigated. The Pr–Fe–Al alloy consisted of the amorphous phase together with the non-ferromagnetic Pr phase. Magnetic measurements confirmed that the origin of coercivity in the alloys was the amorphous phase. It was found that the Curie temperature and coercivity of the alloys were st...
متن کاملOptimization of Microstructure and Mechanical Properties of Al-A360 Produced by Semi-Solid Casting
Semi-Solid Casting (SSM) is a new process that could produce globular structures with mechanical properties. The cooling slope method (CLM) is a one of this process that was employed to produce the A360 feedstock. In this method, The dendritic primary phase in the conventionally cast A356 alloy has transformed into a non-dendritic one. In this paper, The molten alloy with the temperature (PT) o...
متن کاملInvestigation on Mechanical and Electrical Properties of Cu-Ti Nanocomposite Produced by Mechanical Alloying
In this paper, Cu-Ti nanocomposite synthesized via ball milling of copper-titanium powders in 1, 3, and 6 of weight percentage compounds. The vial speed was 350 rpm and ball to powder weight ratio kept at 15:1 under Argon atmosphere, and the time of milling was 90 h. Obtained powders were studied by scanning electron microscopy (SEM), X-ray diffraction (XRD), and dynamic light scattering (DLS)....
متن کاملImproving of Microstructure and Mechanical Properties of Al-A356 Alloy with Compo-Casting Method
Aluminum/alumina composites are used in automotive and aerospace industries due to their low density and good mechanical strength. In this research, the effect of mechanical stirring of slurry in liquid-solid phase temperature and injection of alumina powder with inert gas (Ar) on microstructure and mechanical properties of Al-A356 alloy is investigated. In order to improve of the wettability a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1989
ISSN: 0451-5994
DOI: 10.2464/jilm.39.38