Measurement Technique for Air Capacitance Standards for the Accurate Measurement of Electrical Components using Impedance Analyzers

نویسندگان

چکیده

A measurement technique for a commercial four-terminal (4 T) air-dielectric capacitance standard set (Keysight 16380A) frequencies from 1 kHz up to 13 MHz was developed the accurate calibration of impedance analyzers. The consists at using precision bridge, seven measurements one-port driving point (DPI) over 30 vector network analyzer (VNA), and various numerical calculation procedures parasitic component estimation uncertainty propagation. contribution components in frequency range interest (FRI) estimated by extrapolation measured VNA. linear model employed extrapolate DPIs reliable estimation. Monte-Carlo (MC) simulation. demonstrated better efficacy than others 100 pF 1000 standards FRI applying simple, but models simulation evaluation.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

the use of appropriate madm model for ranking the vendors of mci equipments using fuzzy approach

abstract nowadays, the science of decision making has been paid to more attention due to the complexity of the problems of suppliers selection. as known, one of the efficient tools in economic and human resources development is the extension of communication networks in developing countries. so, the proper selection of suppliers of tc equipments is of concern very much. in this study, a ...

15 صفحه اول

Impedance measurement technique for quantum systems

The impedance measurement technique consists in that the phase-dependent (parametric) inductance of the system is probed by the classical tank circuit via measuring the voltage. The notion of the parametric inductance for the impedance measurement technique is revisited for the case when a quantum system is probed. Measurement of the quantum state of the system of superconducting circuits (qubi...

متن کامل

Mass Flow Measurement of Biofuels using Electrical Capacitance Tomography

Biomass provides 10% of the global energy supply and electricity generation from biomass and waste is expected to increase by a factor of 4 by 2030. Currently efficiency of biomass power generation is poor and IEA targets improvements from 18% to 25% by 2030 [1]. Such increases in efficiency will require significant new technology and accurate real-time measurement of the flow of these highly v...

متن کامل

Standards for Electrical Impedance Mammography

Currently, a variety of electrical impedance diagnostic systems is used both in academic studies and in clinical practice. A significant part of such systems employs electrodes which reside in a single array and two-dimensional mathematical conductivity reconstruction algorithms in the array of the electrodes. Electrical impedance mammograph belongs to the class of 3D tomography systems. Thus, ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Electrical Engineering & Technology

سال: 2021

ISSN: ['1975-0102', '2093-7423']

DOI: https://doi.org/10.1007/s42835-021-00674-z