Measurement of Volumetric Mass Transfer Coefficient in Bubble Columns
نویسندگان
چکیده
منابع مشابه
Experimental measurement of heat transfer coefficient and mass of deposited CaSO4 in subcooled flow boiling condition
Fouling is a common, fundamental and costly problem in heat transfer systems, which reduces thermal efficiency of equipment, increases the energy loss and causes strong damage to the heat transfer equipment in various industries. The main causes of fouling on the heat transfer surfaces are salts with inverse temperature-solubility in the fluid which calcium sulfate is one of the most important ...
متن کاملDetermination of Volumetric Mass Transfer Coefficient in Gas-Solid-Liquid Stirred Vessels Handling High Solids Concentrations: Experiment and Modeling
Rigorous analysis of the determinants of volumetric mass transfer coefficient (kLa) and its accurate forecasting are of vital importance for effectively designing and operating stirred reactors. Majority of the available literature is limited to systems with low solids concentration, while there has always been a need to investigate the gas-liquid hydrodynamics in tanks handling ...
متن کاملMulti-fluid model applied to calculate backmixing and mass transfer in bubble columns
For the calculation of reactive flows in bubble columns the local interfacial area is one of the key parameters. In addition backmixing causes a residence time distribution in the gas and liquid phase, thus mixing phenomena have to be considered as well. The three-dimensional, instationary flow fields in bubble columns are numerically calculated using an Euler multi-fluid model. The resulting s...
متن کاملDynamic measurement of the volumetric oxygen transfer coefficient in fermentation systems.
Introduction Much has been written and said about the scale-up of fermentation systemsS). In general, it has been agreed that the best scale・,-up method is to maintain a constant voiumetric oxygen mass transfer coeMcient. The problem with this procedure has been the differing methods by which the transfer coeMelent has been obtained. Various investigators have used the su}fite oxidation2), pola...
متن کاملGas-liquid mass transfer coefficient in stirred tanks interpreted through bubble contamination kinetics
Experimental data on the average mass transfer liquid film coefficient (kL) in an aerated stirred tank are presented. Liquid media used were tap water, electrolyte solutions and water with controlled addition of tensioactive material. Values of kL range from those expected for bubbles with a mobile surface to those expected for rigid bubbles. These data are quantitatively interpreted in terms o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ChemEngineering
سال: 2018
ISSN: 2305-7084
DOI: 10.3390/chemengineering2020019