Measurement of Tip Clearance of All Blades and the Maximum Tip Clearance Using Discharge-Type Tip Clearance Measurement System.
نویسندگان
چکیده
منابع مشابه
Real-time Tip-clearance Active Control System
Significance of the Problem Control of blade-tip clearance in the compressor and turbine sections of gas turbine engines can improve efficiency, minimize leakage flow, and shorten engine development time. Tip clearance varies throughout different operating conditions (e.g., start-up, idle, full power, shut-down) because of different radial forces and different thermal expansion coefficients and...
متن کاملNew Indices for Detection of Turbine blade Tip Deformation and Estimation of Clearance Extent Using Scattering Parameter
Reliability of gas turbine power plant is related to the blade normal operation. In this paper, a new on-line condition monitoring method has been presented to evaluate two important factors affecting the turbine blades that are the tip clearance and tip deformation. A K band’s microwave sensor has been simulated and optimized in CST Microwave Studio software. Scattering parameters of the near...
متن کاملStudy of Rotor Tip-Clearance Flow Using Large-Eddy Simulation
A large-eddy simulation has been performed to study the temporal and spatial dynamics of a rotor tip-clearance flow, with the objective of determining the underlying mechanisms for low pressure fluctuations downstream of the tip-gap. Simulation results are compared with experimental measurements, and favorable agreements are observed in both qualitative and quantitative sense. Typical vortical ...
متن کاملTip-Clearance Measurement in the First Stage of the Compressor of an Aircraft Engine
In this article, we report the design of a reflective intensity-modulated optical fiber sensor for blade tip-clearance measurement, and the experimental results for the first stage of a compressor of an aircraft engine operating in real conditions. The tests were performed in a ground test cell, where the engine completed four cycles from idling state to takeoff and back to idling state. During...
متن کاملTip Leakage Vortex Cavitation from the Tip Clearance of a Single Hydrofoil
Focusing on the tip leakage vortex cavitation, experimental and numerical studies were carried out as the first step of the investigation of cavitations in tip leakage flow. For a single hydrofoil with a tip clearance, tip leakage vortex cavitations were observed for various cavitation numbers and angles of attack. To simulate the tip leakage vortex cavitation, a simple calculation of 2-D unste...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 2001
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.67.1478