Measurement of Oil Film Pressure at Piston Seals in Pneumatic Cylinders
نویسندگان
چکیده
منابع مشابه
Piston Ring Friction Analysis from Oil Film Thickness Measurements by
The oil film behavior of a series of fifteen lubricating oils was tested in a single cylinder spark ignition engine. The oil film thickness between the piston and cylinder liner of this engine was observed using the Laser Induced Fluorescence (LIF) technique. The data was examined for correlations between physical properties of the oil and characteristics of the oil film. The region of the oil ...
متن کاملCharacteristics of Controlled-clearance Piston-cylinders for Pressure Ranges up to 1 Gpa
− A new controlled-clearance pressure balance has been developed to improve the hydraulic pressure standard for pressures up to 1 GPa. For several controlledclearance piston-cylinders, characterization experiments based on the Heydemann-Welch model were performed to estimate the effective area of them. The results for the piston-cylinders of different pressure ranges are exemplified in this pap...
متن کاملPneumatic cylinders: modelling and feedback force-control
In this paper, we model, analyze, and control an experimental set-up of a servo pneumatic cylinder. The dynamic behaviour of pneumatic actuator systems is dominant by nonlinear functions. First, a mathematical model for the pneumatic system is derived. Secondly, we investigate the mathematical properties of this model and show boundedness and positiveness of certain variables. Thirdly, we prove...
متن کاملPressure Calculation in the Flow Between Two Rotating Eccentric Cylinders at High Renolds Numbers
This paper reports the result of an analytical investigation of a steady, incompressible and viscous flow between two eccentric, rotating cylinders at high Reynolds number. A one dimensional case is far from reality because the gap between the cylinders is very small. Further, when their axes are displaced by a small distance, usually caused by bearing loads, two dimensional effects become obvi...
متن کاملTest Rig for Friction Force Measurements in Pneumatic Components and Seals
This article describes the design of a new test rig for measuring the friction force in pneumatic components and seals. The test rig was designed in order to measure both the overall friction force in a pneumatic cylinder or a valve as a whole, and the single contribution to friction force caused by the sliding seals. To this end, special fixtures and devices were designed and manufactured in o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Society of Instrument and Control Engineers
سال: 2001
ISSN: 0453-4654
DOI: 10.9746/sicetr1965.37.89