Matrix method to solve the inverse problem of heat transfer in heat exchangers

Application of ZnO/TiO2 Nanocomposite for the Improvement of Heat Transfer Coefficient in Tube Heat Exchangers

The potential of nanofluids for the improvement of heat transfer coefficient in various heat exchangeequipment has been considered and studied as a major application during recent decades. In this research,heat transfer coefficient of ZnO, TiO2 and ZnO/TiO2 nanofluids in a shell and tube heat exchanger has beenstudied experimentally. ZnO nanoparticle was synthesized through pre...

Heat Transfer to Separation Flow in Heat Exchangers

using the bees algorithm with the boundary elements method to solve the inverse problem of transient heat conduction

abstract: in this paper, a new population-based search called the bees algorithm (ba) is presented to estimate the time-dependent heat transfer coefficient and the corresponding heat flux at the boundaries of a two-dimensional body subjected to transient heat conduction, using the temperature measurements at discrete nodal locations on the boundaries, where heat flux is specified as the boundar...

Solving an Inverse Heat Conduction Problem by Spline Method

In this paper, a numerical solution of an inverse non-dimensional heat conduction problem by spline method will be considered. The given heat conduction equation, the boundary condition, and the initial condition are presented in a dimensionless form. A set of temperature measurements at a single sensor location inside the heat conduction body is required. The result show that the proposed meth...

Inverse Boundary Design Problem of Combined Radiation-convection Heat Transfer in Laminar Recess Flow

In the present work, an inverse analysis of combined radiation and laminar forced convection heat transfer in a two-dimensional channel with variable cross sections is performed. The conjugate gradient method is used to find the temperature distribution over the heater surface to satisfy the prescribed temperature and heat flux distributions over the design surface. The fluid is considered to b...