Machining Parameters Optimization in End Milling of Ti-6Al-4V

Multi-objective process optimization for micro-end milling of Ti-6Al-4V titanium alloy

Micro-end milling is one of the promising methods for rapid fabrication of features with 3D complex shapes. However, controlling the micro-end milling process to obtain the desired results is much harder compared to that of macro-end milling due to the size effect and uncontrollable factors. The problem is much pronounced when workpiece material is a difficult-to-process material such as titani...

Fuzzy Modeling for Micro EDM Parameters Optimization in Drilling of Biomedical Implants Ti-6Al-4V Alloy for Higher Machining Performance

Ti6Al4V alloy is highly used in the automotive and aerospace industry due to its good machining characteristics. Micro EDM drilling is commonly used to drill micro hole on extremely hard material with very high depth to diameter ratio. In this study, the parameters of micro-electrical discharge machining (EDM) in drilling of Ti6Al4V alloy is optimized for higher machining accuracy with less hol...

Fatigue of Ti-6Al-4V

Metallic biomaterials have essentially three fields of use; these are the artificial hip joints, screw, plates and nails for internal fixation of fractures, and dental implants. Any of these devices must support high mechanical load and resistance of material against breakage is essential. High mechanical properties are needed for structural efficiency of surgical and dental implants. But their...

Fuzzy rule-based for predicting machining performance for SNTR carbide in milling titanium alloy (Ti-6Al-4v)

Experimental Evaluation of Surface Alterations Induced in Machining of Ti-6Al-4V Alloy

Surface integrity of workpieces after machining processes is one of the most essential requirements of engineers in advanced industries, since it has significant effect on performance and service life of the components. Based on this, thermal and mechanical loads generated by machining are responsible for change in mechanical properties of the machined workpiece and consequently, they should be...