MACHINING OF THIN BLADE USING VIBRATION PREDICTIONAND CONTINUOUS SPINDLE SPEED CONTROL
نویسندگان
چکیده
منابع مشابه
Control of a High Speed Machining Spindle via μ-Synthesis
Due to high surface speed and active control capabilities, active magnetic bearings hold great promise for high speed machining spindles. Herein, the control problem posed by this application is examined and the development of an advanced prototype is reviewed. A μ synthesis framework is proposed for this problem and it is shown that the minimization of the susceptibility to machining chatter m...
متن کاملTurbine Blade Tip Leakage Flow Control: Thick/Thin Blade Effects
An experiment was conducted in a linear cascade of Pak-B blades for an exit Mach number of 0.3 to simulate the flow in the tip-gap region of a low pressure turbine blade row. The experiment focused on the independent effects of thickness-to-gap and gapto-chord ratios on the tip-gap flow behavior. Two extreme gap-to-chord ratios of 5% and 8% were chosen, for which four thickness-to-gap ratios we...
متن کاملBlade Tip Clearance and Blade Vibration Measurements Using a Magnetoresistive Sensor
A Blade Tip Timing (BTT) system enables the measurement of turbomachinery blade vibrations by means of contactless sensors mounted in the casing. In addition, the so-called Blade Tip Clearance (BTC) measurement system ensures the monitoring of the existing running gaps between the blade tip and the casing. This paper focuses on the results achieved so far using a novel magnetoresistive sensor f...
متن کاملProcessing Optimization of High Speed Machining in Numerical Control Manufacturing
High cost and low efficiency problem has been bothering NC teaching.To lower the cost of practical teaching of higher speed numerical control manufacturing along with improvement in processing efficiency, a multi-objective scheme for optimization of process parameters has been developed here. Various constraint conditions were set and a complex algorithm was employed for optimization. To achiev...
متن کاملVibration analysis of a steam turbine blade
ABSTRACT Blade failure is a common problem of a steam turbine and it’s failure in-service results in safety risks, repair cost and non operational revenue losses. Thus, the reliability of these blades is very important for the successful operation of a steam turbine. Dynamic analysis of a steam turbine blade in computational environment is carried out in the present work. In order to gain physi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MM Science Journal
سال: 2019
ISSN: 1803-1269,1805-0476
DOI: 10.17973/mmsj.2019_11_2019089