Machining of Composite Materials by Ultrasonic Assistance
نویسندگان
چکیده
منابع مشابه
Machining of Fibre Reinforced Plastic Composite Materials
Fibre reinforced plastic composite materials are difficult to machine because of the anisotropy and inhomogeneity characterizing their microstructure and the abrasiveness of their reinforcement components. During machining, very rapid cutting tool wear development is experienced, and surface integrity damage is often produced in the machined parts. An accurate selection of the proper tool and m...
متن کاملUltrasonic Characterization of Advanced Composite Materials
With increased use of composite materials in critical structural applications it is more important than ever to independently assure structural integrity. Complexity of the advanced composite materials including layered and bonded structures represents challenges in developing optimized ultrasonic tests. Traditional ultrasonic NDT methods are inappropriate and often misleading when applied to a...
متن کاملinvestigation of effective parameters on the rigidity of light composite diaphragms (psscb) by fem
در این رساله با معرفی سقف های psscb متشکل از ترکیب ورق های فولادی ذوزنقه ای و تخته های سیمانی الیافی به عنوان سقف های پیش ساخته (سازگار با سیستم سازه ای قاب های فولادی سبک) به بررسی پارامترهای موثر بر صلبیت سقف، پرداخته می شود. در تحقیق حاضر ابتدا به مدل سازی دو نمونه سقف آزمایش شده، به روش اجزاء محدود با استفاده از نرم افزار تحلیلی abaqus ver 6.10 پرداخته شده است. نمونه های ساخته شده تحت اعما...
Investigation into Machining Characteristics of Tri- Alumane Zirconium Particle Reinforcement in Metal Matrix Composite Using Ultrasonic Machining Process
Particle reinforced metal matrix composites (PRMMCs) are the materials that are extremely difficult to machine using conventional manufacturing method due to high tool wear caused by presence of the hard ceramic reinforcement. This paper presents details of an investigation into the machinability of TriAlumane zirconium (Al3Zr), Zirconia (ZrO2) and Silicon carbide (SiC)particulate reinforcedalu...
متن کاملExperimental Investigation on Over-Cut in Ultrasonic Machining of WC-Co Composite
Abstract—Ultrasonic machining is one of the most widely used non-traditional machining processes for machining of materials that are relatively brittle, hard, and fragile such as advanced ceramics, refractories, crystals, quartz etc. Present article has been targeted at investigating the impact of different experimental conditions (power rating, cobalt content, tool material, thickness of work ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Science and Technology Research Journal
سال: 2020
ISSN: 2080-4075,2299-8624
DOI: 10.12913/22998624/118943