Machinability of SiC particle reinforced aluminum alloy composite material.
نویسندگان
چکیده
منابع مشابه
TENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملMachinability of glass fiber reinforced plastic (GFRP) composite materials
This paper deals with the study of machinability of GFRP composite tubes of different fiber orientation angle vary from 30 to 90. Machining studies were carried out on an all geared lathe using three different cutting tools: namely Carbide (K-20), Cubic Boron Nitride (CBN) and Poly-Crystalline Diamond (PCD). Experiments were conducted based on the established Taguchi’s Design of Experiments (DO...
متن کاملNUCLEATION PHENOMENON IN SiC PARTICULATE REINFORCED MAGNESIUM COMPOSITE
Metal matrix composite (MMC) technology can improve the service performance of matrix metals and alloys. Most magnesium alloy based MMCs are produced via a casting process, therefore the casting microstructures are of vital importance to their performance in service. The formation of microstructure during solidification of MMCs is mainly influenced by four factors: nucleation (or its absence) o...
متن کاملExperimental data on the properties of natural fiber particle reinforced polymer composite material
This paper presents an experimental study on the development of polymer bio-composites. The powdered coconut shell, walnut shells and Rice husk are used as reinforcements with bio epoxy resin to form hybrid composite specimens. The fiber compositions in each specimen are 1:1 while the resin and hardener composition 10:1 respectively. The fabricated composites were tested as per ASTM standards t...
متن کاملMaterial and Information Flows Pertaining to Aluminum Alloy Pipe Distribution
D. Simić, J. Tepić, V. Gajić, I. Kovačević, B. Lalić, Faculty of Technical Sciences, University of Novi Sad, Novi Sad, Serbia This paper discusses the distribution fl ow of aluminum (Al) alloy pipes, starting with the completion of the manufacturing process and fi nal inspection. The proposed solution considers the use of bar-coded caps produced from recycled polymer materials that are placed o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1993
ISSN: 0451-5994
DOI: 10.2464/jilm.43.187