Low Friction Property of DLC-Si Films under Dry Sliding Condition
نویسندگان
چکیده
منابع مشابه
Sliding friction on wet and dry sand.
We show experimentally that the sliding friction on sand is greatly reduced by the addition of some-but not too much-water. The formation of capillary water bridges increases the shear modulus of the sand, which facilitates the sliding. Too much water, on the other hand, makes the capillary bridges coalesce, resulting in a decrease of the modulus; in this case, we observe that the friction coef...
متن کاملSliding Friction on Wet and Dry Sand
Disclaimer/Complaints regulations If you believe that digital publication of certain material infringes any of your rights or (privacy) interests, please let the Library know, stating your reasons. In case of a legitimate complaint, the Library will make the material inaccessible and/or remove it from the website. Please Ask the Library: http://uba.uva.nl/en/contact, or a letter to: Library of ...
متن کاملSliding Friction on Wet and Dry Sand
Disclaimer/Complaints regulations If you believe that digital publication of certain material infringes any of your rights or (privacy) interests, please let the Library know, stating your reasons. In case of a legitimate complaint, the Library will make the material inaccessible and/or remove it from the website. Please Ask the Library: http://uba.uva.nl/en/contact, or a letter to: Library of ...
متن کاملTribological behaviors of several polymer–polymer sliding combinations under dry friction and oil-lubricated conditions
The friction and wear properties of polyamide 66 (PA66), polyphenylene sulfide (PPS) and polytetrafluoroethylene (PTFE) sliding against hemselves under dry sliding and oil-lubricated conditions were studied by using a pin-on-disc tribometer. The effect of applied load and sliding peed on tribological behaviors of the polymer–polymer sliding combinations under dry sliding and oil-lubricated cond...
متن کاملTime resolved friction during dry sliding of metal on metal
In the present study, plate impact pressure±shear friction experiments are conducted to provide insight into timeresolved dry sliding characteristics of metal on metal at normal pressures of approximately 1.5 GPa, slip speeds up to 60 m/s and interfacial temperatures as high as 8008C. The plate impact friction experiments represent a signi®cant improvement over conventional dynamic friction exp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Surface Finishing Society of Japan
سال: 2008
ISSN: 0915-1869
DOI: 10.4139/sfj.59.401