LOAD CARRYING CAPACITY AND SAFETY CHECK OF PRESTRESSED CONCRETE ROCK-SHED
نویسندگان
چکیده
منابع مشابه
Load Carrying Capacity of Simply Supported Variable Thickness Circular Plates
The calculation of the load carrying capacity of variable thickness circular plates subjected to arbitrary rotational symmetric loading is presented. The analysis considers plate materials that obey either the square or the Tresca yield criterion. By using upper and lower bound theorems of limit analysis, corresponding estimations for the load carrying capacity of the plate are obtained. It is ...
متن کاملOptimal Trajectory of Flexible Manipulator with Maximum Load Carrying Capacity
In this paper, a new formulation along with numerical solution for the problem of finding a point-to-point trajectory with maximum load carrying capacities for flexible manipulators is proposed. For rigid manipulators, the major limiting factor in determining the Dynamic Load Carrying Capacity (DLCC) is the joint actuator capacity. The flexibility exhibited by light weight robots or by robots o...
متن کاملDuctility of Prestressed and Partially Prestressed Concrete Beam Sections
D analyses of structures responding elastically to ground motions recorded during severe earthquakes have shown that the theoretical response inertia loads are generally significantly greater than the static design lateral loads recommended by codes. Hence, structures designed for the lateral earthquake loads recommended by codes can only survive severe earthquakes if they have sufficient ducti...
متن کاملPrestressed Concrete Piles
A state of the art presentation on prestressed piling as used throughout the world is discussed in this General Report to the FIP Symposium on Mass-Produced Prestressed Precast Elements in Madrid, Spain, May 1968. Historical information, design data and notes along with manufacturing techniques, installation practices, discussion of problems and failures and a complete bibliography are all cove...
متن کاملDynamic Load Carrying Capacity of Flexible Manipulators Using Finite Element Method and Pontryagin’s Minimum Principle
In this paper, finding Dynamic Load Carrying Capacity (DLCC) of flexible link manipulators in point to-point motion was formulated as an optimal control problem. The finite element method was employed for modelling and deriving the dynamic equations of the system. The study employed indirect solution of optimal control for system motion planning. Due to offline nature of the method, many diffic...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Doboku Gakkai Ronbunshu
سال: 1994
ISSN: 0289-7806,1882-7187
DOI: 10.2208/jscej.1994.495_83