Laser micro- and nano-material processing – Part 2
نویسندگان
چکیده
منابع مشابه
Nonminimum Phase Behavior of Laser Material Processing
Optical sensors are increasingly applied in laser material processing to monitor and control the lasermaterial interaction zone. Dynamic models, relating the sensor signals (e.g. as temperature or molten area) to the process inputs (e.g. laser power or beam velocity), provide the basis for the design and tuning of a feedback controller. These models can show nonminimum phase (NMP) behavior. Thi...
متن کاملAdaptive Optics Control for Laser Material Processing
An adaptive optics system is used for correcting tip-tilt disturbances in an experimental laser material processing setup. The proposed tip-tilt controller is based on PI-controllers that are fed with disturbance estimates from a Kalmanfilter. In addition, delays due to wavefront computation in the wavefront sensor and from data transmission are taken into account in the loop-shaping design. La...
متن کاملTubular filamentation for laser material processing
An open challenge in the important field of femtosecond laser material processing is the controlled internal structuring of dielectric materials. Although the availability of high energy high repetition rate femtosecond lasers has led to many advances in this field, writing structures within transparent dielectrics at intensities exceeding 10(13) W/cm(2) has remained difficult as it is associat...
متن کاملThe Nano–Micro Interface: Bridging Micro and Nano Worlds
By its very title, Nano-Micro Interface: Bridging Micro and Nano Worlds is a timely book for the field of nanotechnology. Since researchers can make microscale objects nanoscale (the top-down approach) as well as atomic and molecular species nanoscale (the bottom-up approach) are there applications in nanoscience and technology that can benefit, or be revolutionized, by combining both approache...
متن کاملLaser‐Material Interaction of Nano‐patterned Ceramic Surfaces
The proposed research is based on previous work in the PI’s laboratory which has led to the development of a low‐cost and high throughput process by which self‐assembled nanostructures can be produced due to a morphological instability created by intermixing of rare earth oxides on yttria‐stabilized zirconia (YSZ) single crystal surfaces leading to the formation of nanoislands or nanobars to re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Optical Technologies
سال: 2020
ISSN: 2192-8584,2192-8576
DOI: 10.1515/aot-2020-0025