Ladle Nozzle Clogging during casting of Silicon-Steel
نویسندگان
چکیده
منابع مشابه
SUBMERGED ENTRY NOZZLE CLOGGING DURING CONTINUOUS CASTING OF Al-KILLED STEEL
F. Tehovnik, J. Burja, B. Arh, Institute of metals and technology, Ljubljana, Slovenia, M. Knap, University of Ljubljana, Faculty of Natural Sciences and Engineering, Ljubljana, Slovenia Nozzle clogging is a common problem in the production of continuously cast Al-killed steels. Clogging occurs when there are solid inclusions in molten steel at casting temperatures. SENs (Submerged entry nozzle...
متن کاملTundish Nozzle Clogging – Application of Computational Models
Clogging of the tundish nozzle is a major castability problem in continuous casting of steel for several reasons. Firstly, clogging increases the frequency of operation disruptions to change nozzles or tundishes or even to stop casting. These extra transitions increase operating cost, decrease productivity, and lower quality. Secondly, clogging can lead directly to a variety of quality problems...
متن کاملClogging in Continuous Casting Nozzles
Nozzle clogging is a serious productivity and quality problem in continuous casting. This work reviews the causes, effects, and solutions to clogging in continuous casting nozzles. The results of a one-dimensional, steady state analysis of the heat loss from the molten steel stream through the nozzle wall are discussed. The analyses show that steel may freeze within the clog matrix for a relati...
متن کاملBasic oxygen furnace based steelmaking processes and cleanliness control at Baosteel
Optical microscopy, total oxygen measurements and slime tests have been conducted to quantify the size distribution and amount of inclusions at various processing steps during basic oxygen furnace (BOF) based steel production at Baosteel. The effects on steel cleanliness of specific operational improvements during steel refining and continuous casting have been investigated. Such improvements t...
متن کاملPhysical Modeling of Steel Delivery during Thin Slab Continuous Casting
A full scale physical model of a thin slab caster with a four-hole design submerged entry nozzle (SEN) was constructed. On the basis of the dimensionless Reynolds and Froude similitude criteria, the fluid flow in a full-scale model is similar to that of the actual system and, hence, the data obtained from the water model can be applied to the actual system. In order to determine the optimum ope...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: High Temperature Materials and Processes
سال: 2019
ISSN: 2191-0324,0334-6455
DOI: 10.1515/htmp-2019-0038