Isothermal Transformation Behavior in 12%Cr-0.3%C Steel
نویسندگان
چکیده
منابع مشابه
Modelling of Kinetics and Dilatometric Behavior of Non-isothermal Pearlite-to-austenite Transformation in an Eutectoid Steel
Austenitization is an inevitable occurrence during the heat treatment of steels. Despite this consideration, less attention has been paid so far to the study of the formation of austenite as compared with the vast amount of research on its decomposition. That is because the steel properties depend basically on the transformation processes following austenitization. However, the initial austenit...
متن کاملIsothermal Recrystallization Behavior of Cold-deformed Martensite in an Ultra-low-carbon Microalloyed Steel
One of the most promising ways to produce a grain-refined microstructure in some steel materials is the thermomechanical processing route of subcritical recrystallization annealing of a cold-deformed martensite structure. In the present study, the microstructural evolutions and the associated recrystallization kinetics under various subcritical annealing heat treatment conditions are explored i...
متن کاملIsothermal and cyclic oxidation behavior of AISI 430 ferritic stainless steel coated with titanium
In order to improve the oxidation resistance of ferritic stainless steel, it is possible to deposit a protective coating on steel substrate. In this research through the usage of pack cementation method a coating of titanium was applied on the surface of AISI 430 stainless steel. Scanning Electron-Microscopy (SEM), Energy- Dispersive X-ray spectrometry (EDAX) and X-ray diffraction (XRD) were us...
متن کاملReal-time synchrotron X-ray diffraction study on the isothermal martensite transformation of maraging steel in high magnetic fields
MATERALIA Group, Department of Physical Metallurgy, Centro Nacional de Investigaciones Metalúrgicas (CENIM-CSIC), Avenida Gregorio del Amo 8, 28040 Madrid, Spain, Fundamental Aspects of Materials and Energy, Faculty of Applied Sciences, Delft University of Technology, Mekelweg 15, 2629 JB Delft, The Netherlands, Dalton Cumbrian Facility, University of Manchester, Westlakes Science and Technolog...
متن کاملIsothermal and Athermal Transformation of FeNiMo Alloys
Kinetic dependence of martensitic transformation and properties changes in Fe-24%Ni5%Mo alloys with different carbon content have been obtained. Internal friction method was used for the precise investigation of structural changes after austenization, during martensitic transformation at sub zero temperature and during the postheat. The influence: (i) of frequency of oscillations, (ii) rate of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2001
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.87.1_49