Investigation of Interface Shape Design for Bonded Dissimilar Materials with Stress Singularity. (2nd Report). Investigation of Interface Shape Design for Bonded Dissimilar Materials with Arbitrary Materials Combination.
نویسندگان
چکیده
منابع مشابه
Spontaneous Mixed-Mode Fracture in Bonded Similar and Dissimilar Materials
In this paper, we report on an experimental study of spontaneous, mixed-mode, crack propagation in weakly bonded similar and dissimilar materials. A unique experimental configuration is proposed to induce spontaneous crack growth events along the interfaces. The cracks nucleate from tiny circular holes and are triggered by an exploding wire. They subsequently propagate under the action of a con...
متن کاملCrack deflection at an interface between dissimilar piezoelectric materials
The problem of crack deflection in bimaterial systems is considered in this paper. The material combinations may be of piezoelectric-piezoelectric, or one is piezoelectric and the other is not. Based on the Stroh formulation for anisotropic material, Green’s functions for various bimaterial combinations are presented within the framework of two-dimensional electroelasticity, allowing the crack ...
متن کاملSlip dynamics at an interface between dissimilar materials
It has been shown recently that steady frictional sliding along an interface between dissimilar elastic solids with Coulomb friction acting at the interface is ill-posed for a wide range of material parameters and friction coefficients. The ill-posedness is manifest in the unstable growth of interfacial disturbances of all wavelengths, with growth rate inversely proportional to the wavelength. ...
متن کاملControl of Welding Residual Stress for Dissimilar Laser Welded Materials
The most common problem of welding dissimilar metals (DMWs) with respect to residual stresses is the differences in the coefficient of thermal expansion and heat conductivity of the two welded metals. In the present work, a CO2 continuous laser welding process was successfully applied and optimized for joining a dissimilar AISI 316 stainless steel and low carbon steel plates. The Taguchi approa...
متن کاملMicro-Study of Dissimilar Welded Materials
The dissimilar joint between aluminum/titanium alloys (Al 6082 and Ti G2) were successfully achieved by CO2 laser welding with a single pass and without filler material using the overlap joint design. Laser welding parameters ranges combinations were experimentally determined using Taguchi approach with the objective of producing welded joint with acceptable welding profile and high quality of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 1996
ISSN: 0288-4771
DOI: 10.2207/qjjws.14.144