Investigation of a fiber-reinforced plastic/rubber adhesive system using statistical experimental design
نویسندگان
چکیده
منابع مشابه
Experimental Investigation of Behavior of Glass Fiber Reinforced Concrete (GFRC)
The paper presents the results of casting and testing of 264 GFRC specimens. The glass fibers were 25 mm long, with the aspect ratio (L/D) ranging between 1250 and 3570. The parameters studied were the ratio (by weight) of fibers to cement, i.e. F/C=0%, 1.5%, 3%, and 4.5%, and the ratio of coarse to fine aggregates (gravel to sand), i.e. G/S=1.1, 0.7 and 0.2. In total, 12 mix designs were selec...
متن کاملExperimental Investigation of Behavior of Glass Fiber Reinforced Concrete (GFRC)
The paper presents the results of casting and testing of 264 GFRC specimens. The glass fibers were 25 mm long, with the aspect ratio (L/D) ranging between 1250 and 3570. The parameters studied were the ratio (by weight) of fibers to cement, i.e. F/C=0%, 1.5%, 3%, and 4.5%, and the ratio of coarse to fine aggregates (gravel to sand), i.e. G/S=1.1, 0.7 and 0.2. In total, 12 mix designs were selec...
متن کاملexperimental and statistical investigation on mechanical properties and impact resistance of synthetic fiber reinforced concrete
in the current study an experimental/statistical approach addressing key mechanical properties (compressive, tensile and flexural strength) and impact resistance of such new fibers with inclusion of different volume of polyphenylene sulfide (pps) fibers has been carried out on 288 specimens. results from this study revealed that compressive, tensile and flexural strength exhibit a good fit with...
متن کاملExperimental investigation of the strength of glass fiber-reinforced concrete exposed to high temperature
This study investigated the effects of high temperature exposure on the compressive, tensile, and flexural strengths of concrete containing glass fiber. A total of 108 cubic specimens (150 mm × 150 mm × 150 mm), cylindrical specimens (300 mm × 150 mm), and prismatic specimens (500 mm × 150 mm × 150 mm) were prepared for compressive, tensile, and flexural strength testing, respectively. The spec...
متن کاملMicrorobot Design Using Fiber Reinforced Composites
Mobile microrobots with characteristic dimensions on the order of 1cm are difficult to design using either MEMS (microelectromechanical systems) technology or precision machining. This is due to the challenges associated with constructing the high strength links and high-speed, low-loss joints with micron scale features required for such systems. Here we present an entirely new framework for cr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymer Testing
سال: 2001
ISSN: 0142-9418
DOI: 10.1016/s0142-9418(00)00010-6