Interlaminar Fracture Toughness of Short Fibre Reinforced GFRP Laminates
نویسندگان
چکیده
منابع مشابه
Fracture toughness, compressive strength and load-bearing capacity of short glass fibre-reinforced composite resin.
OBJECTIVE To investigate the reinforcing effect of short E-glass fibre fillers on fracture related mechanical properties of dental composite resin with a semi-interpenetrating polymer network (IPN) polymer matrix. METHODS Experimental short fibre composite (FC) resin was prepared by mixing 22.5 wt% of short E-glass fibres, 22.5 wt% of IPN-resin and 55 wt% of silane treated silica fillers usin...
متن کاملMode I Interlaminar Fracture Toughness of Unidirectional Fiber-Reinforced Polymer Matrix Composites
1.1 This test method describes the determination of the opening Mode I interlaminar fracture toughness, GIc, of continuous fiber-reinforced composite materials using the double cantilever beam (DCB) specimen (Fig. 1). 1.2 This test method is limited to use with composites consisting of unidirectional carbon fiber and glass fiber tape laminates with brittle and tough single-phase polymer matrice...
متن کاملImprovement of the mode II interface fracture toughness of glass fiber reinforced plastics/aluminum laminates through vapor grown carbon fiber interleaves
The effects of acid treatment, vapor grown carbon fiber (VGCF) interlayer and the angle, i.e., 0° and 90°, between the rolling stripes of an aluminum (Al) plate and the fiber direction of glass fiber reinforced plastics (GFRP) on the mode II interlaminar mechanical properties of GFRP/Al laminates were investigated. The experimental results of an end notched flexure test demonstrate that the aci...
متن کاملMode I Interlaminar Fracture Toughness of Natural Fiber Stitched Flax/Epoxy Composite Laminates – Experimental and Numerical Analysis
The mode I interlaminar fracture toughness of stitched and unstitched composite laminates of continuous UD flax fiber and epoxy matrix was experimentally and numerically investigated. A twistless flax fiber yarn was used for stitching purpose. The mode I interlaminar energy release rate of the unstitched and stitched laminates was experimentally determined through Double Cantilever Beam (DCB) t...
متن کاملDrilling of carbon fibre reinforced laminates – a study
The distinguishing characteristics of carbon fibre reinforced laminates, like low weight, high strength or stiffness, had resulted in an increase of their use during the last decades. Although parts are normally produced to “near-net” shape, machining operations like drilling are still needed. In result of composites non-homogeneity, this operation can lead to delamination, considered the most ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2019
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2019.05.070