Influence of focusing tube wear on vibrations and surface roughness
نویسندگان
چکیده
منابع مشابه
Influence of Focusing Tube Wear on the Cut-surface Quality
The wear of the focusing tube is a very important feature of the abrasive water jet machining. Of all rejected focusing tubes, 85% are worn. Similary, the age of focusing tube influences the cut geometry and quality of machined surface. With regard to the stated, wearing of the focusing tube is subject of this paper. Focusing tube outlet diameter was measured as well as its influence on the sur...
متن کاملSurface morphology in engineering applications: Influence of roughness on sliding and wear in dry fretting
Influence of initial surface roughness on friction and wear processes under fretting conditions was investigated experimentally. Rough surfaces (Ra=0.15-2.52 μm) were prepared on two materials: carbon alloy (AISI 1034) and titanium alloy (Ti-6Al-4V). Strong influence of initial surface roughness on friction and wear processes is reported for both tested materials. Lower coefficient of friction ...
متن کاملInfluence of microwave treatment on surface roughness, hydrophobicity, and chemical composition of galena
The influence of microwave treatment on the surface roughness, hydrophobicity, and chemical composition of galena was studied. The pure galena specimens and purified galena concentrate were used in this work. A conventional multi-modal oven (with a frequency of 2.45 GHz and a maximum power of 900 W) was used to conduct the experiments. The results obtained from the atomic-force microscopy analy...
متن کاملInfluence of Initial Surface Roughness on Severe Wear Volume for SUS304 Austenitic Stainless Steels
Simultaneous measurements of the curves for wear versus distance, wear rate versus distance, and coefficient of friction versus distance were performed in situ to distinguish the transition from severe running-in wear to mild wear. The effects of the initial surface roughness on the severe running-in wear volume were investigated. Disk-on-plate friction and wear tests were carried out with SUS3...
متن کاملinfluence of different proportions of external irrigation during the er,cr:ysgg laser irradiation on wear and roughness of root surface
introduction: the aim of this study was to evaluate the influence of different levels of external irrigation during irradiation with an erbium, chromium: yttrium-scandium-gallium-garnet (er,cr:ysgg) laser on the roughness and wear of dental tissue during scaling procedures. methods: twenty-five uniradicular bovine teeth had the proximal surfaces planed and divided into 3 regions: upper, middle ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tehnicki vjesnik - Technical Gazette
سال: 2015
ISSN: 1330-3651,1848-6339
DOI: 10.17559/tv-20130617095652