Influence of dispersed <mml:math xmlns:mml="http://www.w3.org/1998/Math/MathML" altimg="si1.svg"><mml:mi>β</mml:mi></mml:math> phase on local deformation pattern in mill-annealed Ti-Fe-O alloy under dwell fatigue loading
نویسندگان
چکیده
Grain-scale dwell fatigue behavior in Ti-Fe-O alloy is elucidated, with attention focused on the stress redistribution phenomenon that occurs within soft-hard grain combination. Elastoplastic properties of β phase are determined using nanoindentation and crystal plasticity modeling. On this basis, role intergranular lath evaluated. Redistribution from soft to hard α inhibited presence during period. Meanwhile, peak enhanced. This may result competition two failure modes at high state.
منابع مشابه
Cyclic Deformation, Dislocation Structure, and Internal Fatigue Crack Generation in a Ti-Fe-O Alloy at Liquid Nitrogen Temperature
To clarify the internal fatigue crack generation in a Ti-Fe-O (near a-type) alloy, microstructures, internal fatigue crack initiation sites, and dislocation structures in samples fractured during high-cycle fatigue tests at liquid nitrogen temperature were studied. The alloy contained two kinds of elongated a-phase microstructures, i.e., recovered a grains and recrystallized a grains. Untested ...
متن کاملCyclic deformation and fatigue data for Ti–6Al–4V ELI under variable amplitude loading
This article presents the strain-based experimental data for Ti-6Al-4V ELI under non-constant amplitude cyclic loading. Uniaxial strain-controlled fatigue experiments were conducted under three different loading conditions, including two-level block loading (i.e. high-low and low-high), periodic overload, and variable amplitude loading. Tests were performed under fully-reversed, and mean strain...
متن کاملPhase Changes in Ni-ti under Laser Shock Loading
Near-equiatomic Ni-Ti, known for its shape memory behavior, can decompose to martensitic phases and/or second phase compounds. This phase competition is investigated in NixTi100-x (49<x<55) in as-quenched (AQ) and shock-loaded states. Dynamic loading was done with direct drive laser pulses of nanosecond duration; shocked samples were recovered for analysis. Unexpectedly, the lowest-Ni alloy (x ...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Fatigue
سال: 2021
ISSN: ['1879-3452', '0142-1123']
DOI: https://doi.org/10.1016/j.ijfatigue.2021.106447