Influence of different adherend materials and combinations on in vitro shear bond strength
نویسندگان
چکیده
منابع مشابه
In Vitro Effects of Different Surface Preparation Techniques on Shear Bond Strength of Direct to Indirect Composite Resin
Objective: Repair of an indirect restoration is usually preferred over its replacement. This study aimed to evaluate the effect of silane in different surface preparation techniques on the bond strength of direct to indirect composite resin. Methods: For this in vitro experimental study, 48 indirect composite cubes were fabricated, divided into 4 groups of 12 and subjected to the following ...
متن کاملEvaluation of different surface treatment on shear bond strength of composite to E max porcelain (in-vitro)
Background and Aim: The aim of this study was to investigate the shear bond strengthof composite to Emax porcelain using different methods of ceramic surface preparation (in vitro). Material and Methods: In this laboratory study, 36 porcelain disks were made and divided into four equal groups. The first group was prepared by sandblasting with 50 micron alumina particles, in the second group rec...
متن کاملEvaluation of Shear Bond Strength between Amalgam and Composite: An in vitro Study
Background & Aims: Repair of defective restoration is more conservative than replacing it. Veneering the amalgam restorations with opaque resin materials can satisfy the esthetic demands. Evaluation of interfacial bond quality between amalgam and composite surface is one of the important factors in assessing the quality of repaired amalgam which can be achieved...
متن کاملShear Bond Strength of Acrylic Denture Teeth to PMMA and Polyamide Denture Base Materials
Introduction: Detachment of denture teeth from denture base is one of the most common reasons for costly denture repairs .This study aimed at evaluating the bond strength of an acrylic denture tooth to polyamide injection-molded thermoplastic denture base material compared with three conventional polymethylmethacrylate (PMMA) denture base resins. Materials and Method: A total of 40 acrylic dent...
متن کاملEffect of different surface pre-treatments and luting materials on shear bond strength to PEEK.
OBJECTIVES To assess the bonding potential of a universal composite resin cement and an adhesive/composite system to differently pre-treated PEEK surfaces. METHODS One hundred and fifty PEEK disks were embedded in epoxy resin, polished (P4000 grit) and treated as follows (n=30/group): (A) no treatment, (B) acid etching with sulfuric acid (98%) for 1 min, (C) sandblasting for 10s with 50 micro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Dental Materials Journal
سال: 2013
ISSN: 0287-4547,1881-1361
DOI: 10.4012/dmj.2013-032