Influence Of Deep Cryogenic Processing On Carbide Grain Size In Sintered Carbide WC-Co

Effect of Carbide Particle Size on the Microstructure, Mechanical properties, and Wear Behavior of HVOF-sprayed WC-17% Co Coatings

This study investigates the effect of carbide particle size on the microstructure, mechanical properties, and abrasive wear resistance of WC-17%Co HVOF-sprayed coatings. The characteristics of WC-1, WC-2, and WC-3 coatings with carbide sizes of 1 µm, 0.9 µm, and 0.5 µm, respectively, were also investigated. WC-1 coating experienced the maximum carbon loss of 42%, while WC-2 and WC-3 coatings un...

Influence of electrical discharge machining on sliding friction and wear of WC–Ni cemented carbide

Tribological characteristics of fine-grained WC–8 wt%Ni with different surface finishing conditions corresponding to sequential wire electrical discharge machining (wire-EDM) or grinding were investigated by performing dry reciprocating sliding experiments on TE77 pin-on-plate equipment with WC–6 wt%Co as mating material. Surface finishes and wear surfaces were characterized using surface topog...

Characterization of new Co and Ru on α - WC catalysts for Fischer - Tropsch reaction . Influence of the carbide surface state

An investigation of the performances in Fischer-Tropsch reaction of 1wt% M/WC(X) (M = Co, Ru; X = A, B), where A is a tungsten carbide protected by free carbon and B is a clean tungsten carbide, was carried out. Supported catalysts performances were compared to those of the parent tungsten carbides at 473 K and 20 bar. It was found that WC(A) produces mainly hydrocarbons but also 20-40% alcohol...

Development of Creep-Resistant Tungsten Carbide Copper Cemented Carbide

Fine-grained tungsten carbide copper (WC-Cu) cemented carbide was sintered via spark plasma sintering at 1773K using a fine WC powder with a mean particle size of 0.11 mm. The mechanical properties were compared with tungsten carbide cobalt (WC-Co) cemented carbide and a binderless WC-sintered material. The Vickers hardness and fracture toughness obtained by the indentation fracture method for ...

Boron carbide/n-silicon carbide heterojunction diodes