In situ non-contact measurements of surface roughness
نویسندگان
چکیده
منابع مشابه
In situ non-contact measurements of surface roughness
Surface roughness measurements are often required to validate a machining process. However, when using a 3D surface roughness measuring instruments it is usually necessary to remove the part from the machine tool between two operations, potentially introducing systematic errors. Furthermore, surface roughness measuring instruments are not suited for measuring heavy and large parts such as stamp...
متن کاملNon - contact surface charge / voltage measurements
Methods of measurements of surface electric charges and potentials using electrostatic fieldmeters and voltmeters are discussed. The differences and similarities between those methods are presented. The AC-feedback voltmeter is also described as an unique method that combines advantages of both fieldmeters and voltmeters.
متن کاملNon-contact surface wave measurements on pavements
In this thesis, nondestructive surface wave measurements are presented for characterization of dynamic modulus and layer thickness on different pavements and cement concrete slabs. Air-coupled microphones enable rapid data acquisition without physical contact with the pavement surface. Quality control of asphalt concrete pavements is crucial to verify the specified properties and to prevent pre...
متن کاملNon-Contact Method for Surface Roughness Measurement After Machining
184 Non-Contact Method for Surface Roughness Measurement After Machining J. Valíček, M. Držík, T. Hryniewicz, M. Harničárová, K. Rokosz, M. Kušnerová, K. Barčová, D. Bražina 1 Institute of Physics, Faculty of Mining and Geology, VŠB Technical University of Ostrava, 17. listopadu 15/2172, 708 33 Ostrava-Poruba, Czech Republic, corresponding author: [email protected] 2 Institute of Construction ...
متن کاملAc 2007-2557: Non Contact Surface Roughness Measurement Instrumentation
Saeid Moslehpour, University of Hartford SAEID MOSLEHPOUR is an Assistant Professor in the Electrical and Computer Engineering Department in the College of Engineering, Technology, and Architecture at the University of Hartford. He holds PhD from Iowa State University and BS MS and EdSp degrees from Central Missouri State University. His areas of interest are logic design, CPLDs, FPGAs and dist...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Precision Engineering
سال: 2012
ISSN: 0141-6359
DOI: 10.1016/j.precisioneng.2011.07.011