Improving internal erosion resistance of silty sand using additives
نویسندگان
چکیده
منابع مشابه
evaluation of cone penetration resistance in loose silty sand using calibration chamber
this paper highlights the effect of silt content on cone tip resistance in loose silty sand. in this study, twenty-seven cone penetration tests are performed in saturated silty sand samples with several different silt contents ranging from 10 to 50 percent. the samples are consolidated at three overburden stresses including 100, 200 and 300 kpa. it is shown that, as the silt content increases, ...
متن کاملImpact of Micropiles Installation on Liquefaction Potential of Saturated Silty Sand Using Numerical Method
This paper investigates the effect of micropile installation into saturated sandy soil by means of finite element method. The obtained results from numerical modeling are compared with the received data from the site. The validation of software has been done by simulating standard penetration test. The effect of some changes in spacing (3m, 1.6m and 0.8m) and injection pressure (1cm, 2.5cm, 5cm...
متن کاملImproving the performance of brick blocks for using on sidewalks and rural thoroughfares using additives
Iran is one of the oldest countries in the world in using brick in architecture and construction; most of the architectural structures and rural houses in this country are made of clay; Which has attracted the attention of many tourists; Today, with the advancement of science and technology and the abundance of brick materials and the importance of tourism in Iran, the use of brick block, a met...
متن کاملThe Effects of Grain Size Distribution and Structure on Mechanical Behavior of Silty Sand
In order to investigate the effects of the grain size distribution and the micro-structure of soils on the mechanical characteristics, some static triaxial compression tests were carried out, and then the relationship of stress-strain and the strength behavior of silty sand were compared among undisturbed samples with different grain size distribution, undisturbed and remolded samples with the ...
متن کاملStudy on Pyrolysis of Carbonaceous Additives in Green Sand Foundries
This research evaluated the hydrocarbon emission characteristics during pyrolysis of four carbonaceous additives that can be used in green sand foundries. These included a highly volatile bituminous coal, anthracite, lignite and cellulose. The samples were flash pyrolyzed in a Curie-point pyrolyzer at 920 C with a heating rate of about 3000 C/sec. This simulated the fast heating conditions that...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Dams and Reservoirs
سال: 2020
ISSN: 1368-1494,1756-8404
DOI: 10.1680/jdare.20.00007