IC Chip Stacking Technology Using Flip Chip Bonding.
نویسندگان
چکیده
منابع مشابه
Development of Ultrasonic Flip Chip Bonding Technology
Millimeter wave radars have been developed and marketed for the purpose of reduction in deaths in traffic accidents and traffic congestion. However, the millimeter wave radars need to be cheaper to be used more widely. In order to make the radars cheaper, we developed a new MMIC (Monolithic Microwave IC) structure and bonding technology, focusing on reducing costs of RF-modules. This article de...
متن کاملDesign for Flip-Chip and Chip-Size Package Technology
As new generations of electronic products emerge they often surpass the capability of existing packaging and interconnection technology and the infrastructure needed to support newer technologies. This movement is occurring at all levels: at the IC, at the IC package, at the module, at the hybrid, the PC board which ties all the systems together. Interconnection density and methodology becomes ...
متن کاملFlip-Chip Bonding on 6-um Pitch using Thin-Film Microspring Technology
Bonding-pad densities on high-performance integratedcircuit chips are beginning to exceed the limits of available interconnect technologies. Also, stresses due to thermal mismatch in flip-chipped packages are reducing time to contact failure. We have addressed both of these problems by microlithographically fabricating highly elastic cantilever springs in linear arrays on pitches down to 6 μm. ...
متن کامل3D chip stacking with C4 technology
with C4 technology B. Dang S. L. Wright P. S. Andry E. J. Sprogis C. K. Tsang M. J. Interrante B. C. Webb R. J. Polastre R. R. Horton C. S. Patel A. Sharma J. Zheng K. Sakuma J. U. Knickerbocker Three-dimensional (3D) integration technology promises to continue enhancing integrated-circuit system performance with high bandwidth, low latency, low power, and a small form factor for a variety of a...
متن کاملStatus and Outlooks of Flip Chip Technology
Introduction The flip chip technology was introduced by IBM in the early 1960s for their solid logic technology, which became the logical foundation of the IBM System/360 computer line [1]. Figure 1(a) shows the first IBM flip chip with three terminal transistors, which are Ni/Au plated Cu balls embedded in a Sn–Pb solder bump on the three I/O pads of transistor. A Cr–Cu– Au adhesion/seed layer...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Electronics Packaging
سال: 2002
ISSN: 1343-9677,1884-121X
DOI: 10.5104/jiep.5.185