Hydrogen Embrittlement in Nb-Mo Alloy Films Prepared by Arc-Ion Plating
نویسندگان
چکیده
منابع مشابه
Optimization of the Adhesion Strength of Arc Ion Plating TiAlN Films by the Taguchi Method
A three-level six-factor (arc power, substrate temperature, pre-treatment bias voltage, working pressure, deposition bias voltage and pretreatment time) orthogonal experimental array (L18) to optimize the adhesion strength of arc ion plating (AIP) TiAlN films was designed using the Taguchi method. An optimized film process, namely substrate temperature 220 °C, arc power 60 A, negative bias volt...
متن کاملTetrahedral amorphous carbon films prepared by magnetron sputtering and dc ion plating
Highly tetrahedral, dense amorphous carbon ~ta-C! films have been deposited using rf sputtering of graphite by an unbalanced magnetron with intense dc Ar-ion plating at low temperatures ~,70 °C!. The ratio of the argon ion flux to neutral carbon flux F i/Fn is about 5. The film density and compressive stress are found to pass through a maximum of 2.7 g/cm and 16 GPa, respectively, at an ion pla...
متن کاملPitting-induced hydrogen embrittlement of magnesium- aluminium alloy
In this study, the pitting corrosion susceptibility and its role on the hydrogen embrittlement behavior of AZ80 magnesium alloy were studied using slow strain rate testing (SSRT), electrochemical technique and immersion test method. The electrochemical and immersion tests in chloride-containing solution revealed severe pitting corrosion in the alloy. The SSRT results of the alloy under continuo...
متن کاملElectromagnetic evaluation of hydrogen content in Zr 2.5%Nb alloy
R.Grimberg , M.L.Craus , A.Savin , R.Steigmann , M.Ruch 3 1 National Institute of Research and Development for Technical Physics, Iasi, Romania 2 Joint Institute for Nuclear Research, Dubna, Russia 3 CNEA, Buenos Aires, Argentina Abstract Zr 2.5%Nb alloys have wide utilization in nuclear energy engineering, being used at the fabrication of pressure tubes from Pressurized Heavy Water Reactors (P...
متن کاملAuthor's personal copy Formation and hydrogen storage properties of in situ prepared Mg–Cu alloy nanoparticles by arc discharge
Mg–Cu alloy nanoparticles were in situ prepared by a physical vapor condensation method (arc discharge) in a mixture of argon and hydrogen. Four crystalline phases, Mg, Mg2Cu, MgCu2 and MgO, were formed simultaneously during the arc-discharge evaporation. Detailed experiments revealed that nanostructured hydrogen-active phases of Mg2Cu and Mg exhibit enhanced hydrogen absorption kinetics possib...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 2000
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.64.8_604