High temperature sulfidation-oxidation of stainless steels
نویسندگان
چکیده
منابع مشابه
Low-Temperature Carburization of Austenitic Stainless Steels
LOW-TEMPERATURE CARBURIZATION is a gaseous carburization process performed at atmospheric pressure, at temperatures where the kinetics of substitutional diffusion are very slow. Low-temperature carburization hardens the surface of austenitic stainless steels through the diffusion of interstitial carbon, without the formation of carbides. The surface must be activated, by modification and remova...
متن کاملStudy on Oxidation of Stainless Steels During Hot Rolling
The oxidation of stainless steels 304 and 304L during hot rolling is studied in this paper. Results show the oxide scale thickness decreases significantly with an increase of reduction, and the oxide scales of both 304 and 304L stainless steels were found more deformable than the steel substrate. Surface roughness shows a complicated transfer during the hot rolling process due to the complexity...
متن کاملHigh Temperature Behavior of Dual Phase Steels
Dual phase steels with different martensite volume fraction and morphology were tensile tested at a temperature range of 25 to 5500C. Stress-strain curves of all steels showed serration flow at temperatures of 250 and 3500C, and smooth flow at the other temperatures. Both yield and ultimate tensile strengths increased with increasing testing temperature up to about 450<sup...
متن کاملCharacterization of Austenitic Stainless Steels Deformed at Elevated Temperature
Highly alloyed austenitic stainless steels are promising candidates to replace more expensive nickel-based alloys within the energy-producing industry. The present study investigates the deformation mechanisms by microstructural characterization, mechanical properties and stress–strain response of three commercial austenitic stainless steels and two commercial nickel-based alloys using uniaxial...
متن کاملTensile Tests on Stainless Steels in Temperature Range
In real conditions, austenitic stainless steels solidify in non equilibrium and a two phases microstructure of austenite and ferrite is formed 1 . The aim of this work was to investigate the behaviour of both phases at tensile testing, especially to find out an eventual difference in the relaxation of the deformation energy and the effect of the two phases microstructure in workability. To achi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Le Journal de Physique IV
سال: 1993
ISSN: 1155-4339
DOI: 10.1051/jp4:1993936