High Temperature Strength of Dissimilar Welded Joint
نویسندگان
چکیده
منابع مشابه
Micro-Study of Dissimilar Welded Materials
The dissimilar joint between aluminum/titanium alloys (Al 6082 and Ti G2) were successfully achieved by CO2 laser welding with a single pass and without filler material using the overlap joint design. Laser welding parameters ranges combinations were experimentally determined using Taguchi approach with the objective of producing welded joint with acceptable welding profile and high quality of ...
متن کاملMicrostructure Evolution and Shaping of Friction Stir Lap Welded Dissimilar Magnesium Alloy Joint
Friction stir lap welding (FSLW) experiment has been conducted on 3mm thick AZ80 extruded sheet and 2.3mm thick AZ31B rolled sheet. The influence of the shape of the taper thread mixing head on microstructure has been discussed. Pores forming, hooked defects, interface migration, tissue distribution have been analyzed. The organization of both sides of nugget zone (NZ) is arranged diagonally ab...
متن کاملStructural, Chemical and Deformation Changes in Friction Welded Joint of Dissimilar Steels
N. Ratković, Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia. R. Nikolić, Faculty of Civil Engineering, University of Žilina, Žilina, Slovakia. I. Samardžić, University of Osijek, Mechanical Engineering Faculty in Slavonski Brod, Croatia. Fundamental principles of friction welding of dissimilar steels (high speed and tempering steel) from the aspect of metallurgical and che...
متن کاملControl of Welding Residual Stress for Dissimilar Laser Welded Materials
The most common problem of welding dissimilar metals (DMWs) with respect to residual stresses is the differences in the coefficient of thermal expansion and heat conductivity of the two welded metals. In the present work, a CO2 continuous laser welding process was successfully applied and optimized for joining a dissimilar AISI 316 stainless steel and low carbon steel plates. The Taguchi approa...
متن کاملEffect of tool position on microstructural and mechanical properties of friction stir butt welded joint of AA2024–AA7075 dissimilar alloys
In this research, butt joining of Al2024 and Al7075 plates were performed by Friction Stir Welding (FSW) and the effect of tool position on microstructural and mechanical properties in about 1 mm from center line of joint towards the advancing side (AS) and the retreating side (RS) was investigated at three positions of +1, 0, -1 mm. In this regard, the plates of Al2024 and Al7075 were selected...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1963
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.32.595