Heat Transfer in Boiling from Horizontal Tube Enclosed by Concentric Outer Tube with Two Horizontal Slender Holes.

Saturated Flow Boiling Heat Transfer in Horizontal Square Tube

Heat Transfer Efficiency of Turbulent Film Boiling on a Horizontal Elliptical Tube with External Flowing Liquid

Film boiling on a horizontal elliptical tube immersed in external flowing nitrogen liquid is investigated in the present paper. The isothermal wall temperature is high enough to induce turbulent film boiling, and then a continuous vapor film runs upward over the surface. The high velocity of the flowing saturated liquid at the boundary layer is determined by potential flow theory. In addition, ...

Flow Boiling Heat Transfer of Binary Mixtures HFO1234yf/R32 in a Smooth Horizontal Tube

HFO1234yf is a promising alternative for automobile air conditioners because of its low GWP of 4 and thermophysical properties similar to those of R134a. However, its performance is inferior to R410A. This makes it difficult to be applied to residential air-conditioners. A mixture of HFO1234yf and R32 is expected to balance both the GWP and COP requirement when applied to residential air-condit...

Flow Boiling Heat Transfer and Pressure Drop of R1234ze(E) and R32 in a Horizontal Micro-Fin Tube

In the present study, the flow boiling heat transfer of R1234ze(E), R32 and zeotropic mixture R1234ze(E)/R32 (50/50 mass%) in a horizontal micro-fin tube is experimentally investigated to clarify the pressure drop and heat transfer characteristics. Tested micro-fin tube is made of copper, and its geometry is as follows, 6.00 mm in outer diameter, 5.21 mm in mean inside diameter, 0.26 mm in fin ...

Numerical Investigation on Slot air Jet impingement Heat Transfer between Horizontal Concentric Circular Cylinders

A numerical study has been carried out for slot air jet impingement cooling of horizontal concentric circular cylinders. The slot air jet is situated at the symmetry line of a horizontal cylinder along the gravity vector and impinges on the bottom of the outer cylinder which is designated as θ=0°. The outer cylinder is partially opened at the top with a width of W=30mm and is kept at constant t...