Heat (Mass) Transfer Characteristics in the Entrance Region of Rib-Roughened Rectangular Ducts.
نویسندگان
چکیده
منابع مشابه
Average Heat Transfer Coefficient in Rectangular Ducts with Baffle Blockages
An experimental investigation was conducted to study the average and the fully-developed heat (mass) transfer coefficients in a rectangular smooth duct and a duct with repeated-baffle blockages. The focus of attention in this work is the conventional correlation Nu / Nufd 1 + C / ( X / D ) for the average heat transfer coefficient. It was shown that for relatively short ducts, the coefficient C...
متن کاملNumerical investigation of heat transfer and laminar Water-Al2O3 nanofluid flow in a rectangular Rib-Microchannel
در تحقیق حاضر در مورد اثرات ارتفاع دندانه در میکروکانال دندانه‌دار دو بعدی، بر روی پارامترهای انتقال حرارت و دینامیک سیالات محاسباتی جریان آرام نانوسیال آب-اکسید آلومینیم است. بررسی‌های این تحقیق به صورت عددی با نرم افزار تجاری فلوئنت3/6 برای اعداد رینولدز10 و 100، برای چهار حالت مختلف ارتفاع دندانه انجام شده است. افزایش ارتفاع دندانه‌های داخلی یا مغشوشگرهای جریان، عملکرد انتقال حرارت جابجایی د...
متن کاملnumerical investigation of heat transfer and laminar water-al2o3 nanofluid flow in a rectangular rib-microchannel
0
متن کاملFluid flow and heat transfer characteristics in a curved rectangular duct using Al2O3-water nanofluid
In the present research, the laminar forced convective heat transfer and fluid flow characteristics for Al2O3-water nanofluid flowing in different bend (i.e., 180o and 90o) pipes have been investigated numerically in a three-dimensional computational domain using the finite volume technique. The effects of different pertinent parameters, such as the Reynolds number of the duct, volume fraction ...
متن کاملMeasurement of Heat Transfer in the Entrance Region of Small Diameter Tubes
Heat transfer coefficient in the entrance region of water flowing through micro-tubes with diameters of 962 μm and 123 μm was investigated in this study. Two temperature measurement methods, thermocouple and liquid crystal thermography (LCT), were used to measure the tube surface temperature. The experimental data showed that the Nu in the entrance region can be predicted well by conventional c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1997
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.63.1327