Heat Induced Desorption of Moisture in Timber Joints with Fastener During Charring
نویسندگان
چکیده
منابع مشابه
Moisture absorption-desorption effects in adhesive joints
This paper presents a study of moisture absorption-desorption effects in single lap adhesive joints. Experiments were carried out to characterise the moisture uptake of the single part epoxide adhesive, FM73. Tensile testing of single lap joints manufactured from aluminium alloy 2024 T3 and O and FM73 adhesive was carried out after the joints were exposed to different conditioning environments....
متن کاملBolted Timber Joints with Self-tapping Screws
The use of self-tapping screws with continuous threads in the joint area as a reinforcement to avoid splitting of timber members is studied. A theoretical model is developed to calculate the stress distribution around a pin-loaded hole in a timber joint, to predict brittle failure modes in bolted connections and to calculate the load in the reinforcing screws. Laboratory experiments on reinforc...
متن کاملTests to Determine the Joint Stiffness and Resisting Moment Capacity of Joints in Timber-Framed Houses
Wind and earthquake disasters in the world often cause billions of dollars of damage to buildings, most of which is to non-engineered buildings-especially homes. Wood-frame homes use connectors which exhibit partial rotational rigidity at the member ends, making analytical solutions difficult. This is due to the lack of information about the complex behavior of the connections used in this type...
متن کاملMoisture Desorption Isotherms and Isosteric Heat of Sorption Characteristics of Malting Barley (hordeum Distichum L.)
The equilibrium moisture content of malting barley grains (cv. Scarlett) was determined by gravimetric-static method in the range 20-50°C using saturated salt solutions (LiCl, MgCl2.6H2O, K2CO3, NaBr, NaNO2, KI, NaNO3, NaCl, (NH4)2SO4) to provide water activities for each temperature between 0.11 and 0.813. Desorption isotherms were obtained at 20, 30, 40, and 50°C. All the sorption curves w...
متن کاملHeat Transfer Modeling of a Charring Material Using
An isoconversional modeling approach has been considered in the modeling of heat transfer and pyrolysis in a charring material. The isoconversional approach is appealing due to the use of only a single reacting component as opposed to the multicomponent model typically used. This reduces the number of required field variables which reduces numerical demands in large multi-dimensional models. In...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Fire Technology
سال: 2014
ISSN: 0015-2684,1572-8099
DOI: 10.1007/s10694-014-0416-3