Grain structure evolution during friction-stir welding of 6061-T6 aluminum alloy
نویسندگان
چکیده
Abstract In this work, electron backscattered diffraction (EBSD) was used to examine the evolution of grain structure during friction stir welding aluminum alloy 6061-T6. entire FSW range studied, microstructure found be governed by continuous recrystallization. An increase in temperature resulted only microstructural coarsening.
منابع مشابه
Feasibility study of friction stir welding of 6061-T6 aluminium alloy with AISI 1018 steel
The present work demonstrates that friction stir welding (FSW) is a feasible route for joining 6061 aluminium (Al) alloy to AISI 1018 steel. The weld has a good weld quality and is free of cracks and porosity. The tensile failure happened at the boundary between the nugget and thermomechanically affected zone of the base Al alloy, indicating that the weld has a higher joining strength. Despite ...
متن کاملTwo-dimensional Mapping of Residual Strains in 6061-t6 Aluminum Alloy Friction Stir Welds
The residual strain profiles were measured through the thickness of friction-stir welded (FSW) plates using neutron diffraction to study the relationship between the angular distortion and the residual strain distribution. Three different weld specimens were prepared from a 6061-T6 aluminum alloy with the purpose of separating the effects of the frictional heat and plastic deformation on the re...
متن کاملAnalysis and Comparison of Friction Stir Welding and Laser Assisted Friction Stir Welding of Aluminum Alloy
Friction Stir Welding (FSW) is a solid-state joining process; i.e., no melting occurs. The welding process is promoted by the rotation and translation of an axis-symmetric non-consumable tool along the weld centerline. Thus, the FSW process is performed at much lower temperatures than conventional fusion welding, nevertheless it has some disadvantages. Laser Assisted Friction Stir Welding (LAFS...
متن کاملMicrostructure and Mechanical Properties of Dissimilar Friction Stir Welding between Ultrafine Grained 1050 and 6061-T6 Aluminum Alloys
The ultrafine grained (UFGed) 1050 Al plates with a thickness of 2 mm, which were produced by the accumulative roll bonding technique after five cycles, were friction stir butt welded to 2 mm thick 6061-T6 Al alloy plates at a different revolutionary pitch that varied from 0.5 to 1.25 mm/rev. In the stir zone, the initial nano-sized lamellar structure of the UFGed 1050 Al alloy plate transforme...
متن کاملFinite element simulation of microstructure evolution during friction stir welding of automotive aluminum parts
7000 series Aluminum alloys are widely used in the automotive industries for structural lightweight components due to their exceptional high strength to weight ratio. However, this class of aluminum alloy is difficult to join by conventional fusion welding techniques so Friction stir welding (FSW) widely is used for welding this alloys. The process has been demonstrated to be effective and is c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP conference series
سال: 2021
ISSN: ['1757-899X', '1757-8981']
DOI: https://doi.org/10.1088/1757-899x/1014/1/012015