Grain Growth in the Hyper Interfacial Bonded Layer of Ultra Fine-Grained Steels
نویسندگان
چکیده
منابع مشابه
Ultra-Fine Grained Dual-Phase Steels
This paper provides an overview on obtaining low-carbon ultra-fine grained dual-phase steels through rapid intercritical annealing of cold-rolled sheet as improved materials for automotive applications. A laboratory processing route was designed that involves cold-rolling of a tempered martensite structure followed by a second tempering step to produce a fine grained aggregate of ferrite and ca...
متن کاملultra-fine grained dual-phase steels
this paper provides an overview on obtaining low-carbon ultra-fine grained dual-phase steels through rapid intercritical annealing of cold-rolled sheet as improved materials for automotive applications. a laboratory processing route was designed that involves cold-rolling of a tempered martensite structure followed by a second tempering step to produce a fine grained aggregate of ferrite and ca...
متن کاملULTRA FINE FERRITE FORMATION IN Si-Mn TRIP STEELS
Abstract: In the present investigation, the effects of thermomechanical processing parameters and the steel chemical composition on the ultra fine ferrite formation characteristics were studied. This was programmed relying on the capabilities of strain induced transformation (SIT) phenomenon and applying to different grades of Si-Mn TRIP (Transformation Induced Plasticity) steels. According...
متن کاملIntermittent ‘self-locking’ of Grain Growth in Fine-grained Materials
Grain boundary motion may be accompanied with vacancy generation [1–4]. A typical case where a moving grain boundary produces vacancies is in primary recrystallisation, when the growth of a recrystallised grain at the cost of a grain with a large dislocation density involves release of excess free volume. Vacancies are also generated during grain growth, when the total volume of the grain bound...
متن کاملOptimization of ECMAP parameters in production of ultra-fine grained Al1050 strips using Grey relational analysis
Production of lightweight metals with a higher strength to weight ratio is always the main goal of researchers. In this article, equal channel multi angular pressing (ECMAP) process as one of the most appealing severe plastic deformation (SPD) methods on production of ultra-fine grained (UFG) materials studied. Two main routes A and C investigated by FEM and compared with each other from differ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals
سال: 2004
ISSN: 0021-4876
DOI: 10.2320/jinstmet.68.333