Fundamental study on zinc sulfation roasting reaction.
نویسندگان
چکیده
منابع مشابه
A Fundamental Study on Uranium Isotope Separation Using U(IV)—U(VI) Electron Exchange Reaction
für Naturforschung in cooperation with the Max Planck Society for the Advancement of Science under a Creative Commons Attribution 4.0 International License. Dieses Werk wurde im Jahr 2013 vom Verlag Zeitschrift für Naturforschung in Zusammenarbeit mit der Max-Planck-Gesellschaft zur Förderung der Wissenschaften e.V. digitalisiert und unter folgender Lizenz veröffentlicht: Creative Commons Namen...
متن کاملDielectric Properties of Zinc Sulfide Concentrate during the Roasting at Microwave Frequencies
Microwave technology has a potential application in the extraction of zinc from sulphide ores, knowledge of the dielectric properties of these ores plays a major role in the microwave design and simulation for any process. The dielectric properties of zinc sulfide concentrate for two different apparent densities—1.54 and 1.63 g/cm3—have been measured by using the resonance cavity perturbation t...
متن کاملCoffee roasting acoustics.
Cracking sounds emitted by coffee beans during the roasting process were recorded and analyzed to investigate the potential of using the sounds as the basis for an automated roast monitoring technique. Three parameters were found that could be exploited. Near the end of the roasting process, sounds known as "first crack" exhibit a higher acoustic amplitude than sounds emitted later, known as "s...
متن کاملStudy of Acrylamide Formation in Coffee during Roasting
Coffee is a popular beverage in society. Acrylamide is an undesirable substance that will metabolically activated to carcinogens.Acrylamide formation is found to occur during the browning process, which is called Maillard reaction. This is the reaction between sugars and asparagines at temperature above 120°C. The roasting temperature of coffee is at least 200°C, meaning that coffee surely cont...
متن کاملFundamental Study on Cross Axis Grinding Method
In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Shigen-to-Sozai
سال: 1989
ISSN: 0916-1740,1880-6244
DOI: 10.2473/shigentosozai.105.639