Frictional heating in a unidirectional fibre-reinforced ceramic composite
نویسندگان
چکیده
منابع مشابه
Frictional heating in a unidirectional fibre-reinforced ceramic composite
Holmes and Shuler [1] recently found that significant internal heating occurs during the cyclic loading of fibre-reinforced ceramics. In their investigation, conducted with cross-ply carbon fibre/SiC matrix composites (hereafter referred to as Cf/SiC), it was observed that the extent of internal heating was strongly influenced by the peak fatigue stress and loading frequency. For example, durin...
متن کاملSome observations in grinding unidirectional carbon fibre-reinforced plastics
This paper investigates the grinding performance of epoxy matrix composites reinforced by unidirectional carbon fibres, using an alumina grinding wheel. Emphasis was placed on understanding the effect of fibre orientations and grinding depths on the grinding force and surface integrity, and on understanding the grinding mechanisms, with a comparison to orthogonal cutting. It was found that grea...
متن کاملMachining of Fibre Reinforced Plastic Composite Materials
Fibre reinforced plastic composite materials are difficult to machine because of the anisotropy and inhomogeneity characterizing their microstructure and the abrasiveness of their reinforcement components. During machining, very rapid cutting tool wear development is experienced, and surface integrity damage is often produced in the machined parts. An accurate selection of the proper tool and m...
متن کاملOn the Elastic Moduli of Unidirectional Fibre Reinforced Composites
A simple analytical technique is presented for obtaining lower bounds to the effective moduli of unidirec-tional fibre-reinforced composites with any repetitive array of fibres. The analysis depends upon a direct method involving stress-equilibrium and strain-continuity considerations, and thus it differs from the type of analysis due to Hashin and Hill (and others) involving variational method...
متن کاملWear of ceramic-on-carbon fibre reinforced PEEK hip replacements
Total hip replacement has been a successful surgical intervention for many years. However, concerns regarding UHMWPE wear particle induced osteolysis [1], have led to alternative bearing materials to be sought. Carbon-fibre reinforced poly-ether-ether-ketone (CFR-PEEK) is a fibre-reinforced polymer which has shown reduced wear in hip and knee configurations compared with conventional polyethyle...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Science Letters
سال: 1992
ISSN: 0261-8028,1573-4811
DOI: 10.1007/bf00720776